Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3 Safety Precautions and Warnings
To prevent personal injury or damage to vehicles and/or the brake tool, read this instruction manual
first and observe the following safety precautions at a minimum whenever working on a vehicle:
Always perform automotive testing in a safe environment.
Wear safety eye protection that meets ANSI standards.
Keep clothing, hair, hands, tools, test equipment, etc. away from all moving or hot engine parts.
Operate the vehicle in a well ventilated work area: Exhaust gases are poisonous.
Put blocks in front of the drive wheels and never leave the vehicle unattended while running tests.
Use extreme caution when working around the ignition coil, distributor cap, ignition wires and spark
plugs. These components create hazardous voltages when the engine is running.
Keep a fire extinguisher suitable for gasoline/chemical/electrical fires nearby.
Don't connect or disconnect any test equipment while the ignition is on or the engine is running.
Keep the brake tool dry, clean, and free from oil/water or grease. Use a mild detergent on a clean
cloth to clean the outside of the brake tool, when necessary.
3 Location of Data Link Connector (DLC
The DLC (Data Link Connector or Diagnostic Link Connector is the standardized 16-cavity connector
where diagnostic brake tool interface with the vehicle's on-board computer. The DLC is usually
located 12 inches from
the center of the instrument panel (dash, under or around the driver's side
for most vehicles. If Data Link Connector is not located under dashboard, a
label should be there telling location. For some Asian and European vehicles,
the DLC is located behind the ashtray and the ashtray must be removed
to access the connector. If the DLC can not be found, refer to the vehicle's
service manual for the location.
3 Using the EPB Service Tool
3.1 Tool Description
1. LCD DISPLAY - Indicates test results.
2. Y BUTTON - Confirms a selection (or action from a
menu list, or enters to next menu.
3. N BUTTON - Cancels a selection (or action from a
menu or returns to previous menu.
4. UP SCROLL BUTTON - Moves up through menu and
submenu items in menu mode.
5. DOWN SCROLL BUTTON - Moves down through menu
and submenu items in menu mode.
6. POWER BUTTON - Turns on/off the brake tool when
powered by the vehicle or cell battery; resets the tool also.
7. OBD II CABEL - Connects the brake tool to the vehicle's
Data Link Connector (DLC.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
2
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Capítulos
Tabla de contenido
