Troubleshooting - Black and Decker HGS500 Manual De Uso Y Cuidado

TROUBLESHOOTING

PROBLEM
Not enough steam or no
steam is coming out of the
steamer.
Discolored water is
coming through the holes
and staining the fabric.
Iron/steamer is leaking or
spitting.
10
POSSIBLE CAUSE
The iron/steamer is not heated to full
temperature.
There is not enough water in the water tank.
The water pump hasn't been primed. If unit
still will not steam, move the unit around or
shake to assist with priming.
Residue has built up in the water tank.
Perfumed or scented additives were used.
Iron/steamer is not hot enough.
Water tank is running low.
SOLUTION
Always allow iron/steamer to preheat at
least 45 seconds, or until the power button
light stops flashing.
Fill the water tank.
After preheating, always prime the water
pump by holding the steam trigger until
steam forms.
Empty the water tank after each use. Only
use distilled, filtered, or purified water.
Never use perfumed or scented additives.
Allow the iron/steamer to heat for about 45
seconds.
Fill the water tank.