Reliable DASH 100GH Manual De Instrucciones página 12

on furniture and cushions from the furniture and in the room. Before steaming,
always test on a small area of the fabric that is not visible.
2. Keeping the garment steamer in an upright position and using an up and down
motion, lightly steam over the fabric of your furniture. Cushions should be
removed and held upright for steaming. Allow cushions to dry thoroughly before
replacing on furniture.
NOTE: It is recommended that you use the fabric brush attachment when steaming
delicate fabrics such as silk, this will minimize any damage to the garment whilst
steaming. For better results when removing stubborn creases, remove the fabric
brush attachment from the steam head and continuously steam over the selected
area until creases are removed.
WARNING: If garment has metal accessories, be cautious and do not position the
garment steamer
WARNING: Always unplug the garment steamer, and allow to cool down, before
attaching or detaching the fabric brush.
NOTE: Only use the attachments or accessories provided.
NOTE: If the unit becomes noisy with a loud humming sound and no steam is being
generated, check the water level in the water tank. This may be an indication that
the garment steamer is out of water and needs to be refilled.
WARNING: Do not use the garment steamer directly on persons, animals, or while
wearing the garments.
WHEN YOU ARE FINISHED USING THE STEAMER
• Press the power button , switch the power off at the power outlet and
disconnect the power cord from the power outlet.
• Open the water tank inlet and (over a sink or bucket) invert the water tank to
empty the remaining water from the tank.
• Stand the garment steamer on its base, in an upright position, and allow it to
cool down.
CARE, CLEANING AND STORAGE CARE
AND CLEANING
• Remove the fabric brush from its steam head and clean using a damp cloth.
• Do not use harsh or abrasive cleaning agents or solvents.
• Do not put the garment steamer in water or any other liquid.
• Do not drop or throw the steamer.
09
directly over the metal as this may discolour the metal.