Detergent And Dishwasher Use; Measuring Out The Detergent; Starting The Dishwasher - Hotpoint Ariston LFF 8M116 Manual De Instrucciones

Detergent and
dishwasher use

Measuring out the detergent

Good washing results also depend on the correct amount of
detergent being used. Exceeding the stated amount does not
result in a more effective wash and increases environmental
pollution.
The amount can be adjusted to the soil level.
In the case of normally soiled items, use approximately either
35g (powder detergent) or 35ml (liquid detergent). If tablets
are used, one tablet will be enough.
If the crockery is only lightly soiled or if it has been rinsed
with water before being placed in the dishwasher, reduce the
amount of detergent used accordingly.
For good washing results also follow the instructions shown
on the detergent box.
For further questions please ask the detergent producers.
To open the detergent dispenser use the opening device "A".
Introduce the detergent into the dry dispenser "B" only.
Place the amount of detergent for pre-washing directly inside
the tub.
1. When measuring out the detergent refer to the Table of wash
cycles to add the proper quantity. Compartment B comprises a
level showing the maximum quantity of liquid or powder detergent
that can be added to each cycle.
2. Remove detergent residues from the edges of the dispenser
and close the cover until it clicks.
3. Close the lid of the detergent dispenser by pulling it up until
the closing device is secured in place.
The detergent dispenser automatically opens up at the right time
according to the wash cycle.
If all-in-one detergents are used, we recommend using the TABS
option, because it adjusts the cycle so that the best washing and
drying results are always achieved.
Only use detergent which has been specifically designed
for dishwashers.
DO NOT USE washing up liquid.
Using excessive detergent may result in foam residues
remaining in the machine after the cycle has ended.
To achieve the best washing and drying results, the combined
use of detergent, rinse aid liquid and refined salt is required.
We recommend using detergents that do not contain
phosphates or chlorine, as these products are harmful
to the environment.
All manuals and user guides at all-guides.com

Starting the dishwasher

1. Press the ON/OFF button.
2. Open the door and pour in a suitable amount of detergent
(see detergent).
3. Load the racks
4. Select the wash cycle in accordance with the type of crockery
and its soil level
wash-cycle selection buttons.
5. Select the wash options
6. Start the cycle by pressing the Start/Pause button: The wash
indicator light comes on and the time left to the end of the cycle
appears on the display.
7. At the end of the cycle, the display shows END. Switch off the
appliance by pressing the ON/OFF button.
8. Wait for a few minutes before removing the crockery in order
to avoid burns. Unload the racks, beginning with the lower level.
periods of inactivity in order to minimise electricity
consumption.
equipped with a special sensor which can be used to assess the
level of soiling and automatically select the most efficient and
economical wash cycle accordingly. The duration of the auto
wash cycles may vary due to the operation of the sensor.
Changing a wash cycle in progress
If a mistake was made in the wash cycle selection process, it is
possible to change the cycle provided that it has only just begun:
once the wash cycle has started, in order to change the wash
cycle switch off the machine by pressing and holding the ON/
OFF/Reset button. Switch it back on using the same button and
select the desired wash cycle and options.
Adding extra crockery
Press the Start/Pause button and open the door, taking care to
avoid the escaping steam, and place the crockery inside the
dishwasher. Press the Start/Pause button: The cycle will start
again after a long beep has been emitted.
the wash cycle will not start. It will stay in Pause mode.
cycle is stopped.
At this stage it is not possible to change the wash cycle.
Accidental interruptions
If the door is opened during the wash cycle or there is a power
cut, the cycle stops. It starts again from the point at which it was
interrupted once the door has been shut or the electricity supply
is restored.
(see Loading the racks)
(see Table of wash cycles)
*
( see wash options) .
The machine will switch off automatically during long
*
:
AUTO WASH CYCLES some dishwasher models are
If the delayed start has been set, at the end of the countdown
Press the Start/Pause button to pause the machine; the wash
EN
and shut the door.
by pressing the
19