Electrical Connection - Brandt Four Manual De Instrucciones

2 / INSTALLING YOUR APPLIANCE
Single-phase line
16A fuse or residual
current circuit breaker
2-prong
+ earth plug
CEI Standard 60083

• ELECTRICAL CONNECTION

The appliance must be correctly built in to
ensure electrical safety. During fitting and
maintenance operations, the appliance must
be unplugged from the electrical grid; fuses
must be switched off or removed.
The electrical connections should be made
before the appliance is installed in its
housing.
Ensure that:
- the electrical installation is sufficiently
rated,
- the electrical wires are in good condition,
- the diameter of the wires complies with the
installation requirements.
The oven must be connected with a power
cable (standardised) with 3 1.5mm 2
conductors (1 ph +1N + ground) that must
be connected to a monophase 220-240 V ~
network via a CEI 60083 standardised
receptacle 1 ph +1 neutral + ground lead or
an all-pole cut-off device in accordance with
installation rules.
220-240 V ~
Power cable
approximately
1.50 m long
Single phase 20A Meter
220-240V ~ 50Hz-60Hz
Caution:
The safety wire (green-yellow) is connected
to the appliance's
connected to the installation's earth.
You must enable the appliance to be
disconnected from the supply network after
installation.
The appliance can be disconnected by
using an accessible power outlet or by
incorporating a switch in the fixed lines, in
accordance with the installation rules.
The fuse in your set-up must be
16 amperes.
If the power cable is damaged, it should be
replaced by the manufacturer, its after-
sales service department or a similarly
qualified person, so as to avoid danger.
EN-9
EN
terminal and must be