Kohler K-300 Instrucciones De Instalación página 7

5. INSTALL OPTIONAL HANDLES AND SPOUT
Ensure valves are closed (cold fully counterclockwise, hot
fully clockwise).
Turn off main water supply.
WARNING: Risk of personal injury. Lines may be
pressurized. Do not lean over pipe plug when turning
or removing the plug.
Wrap a towel around the pipe plug to prevent water spray.
Water may purge from the supply tube when you remove
the plug.
Carefully remove pipe plug.
Remove cardboard plaster guards from both valve bodies
and from spout supply tube.
Install spout using spout instructions packed with spout.
If spout supply tube must be cut, be sure to purge supply
tube of debris before connecting spout.
Install handles using instructions packed with handles.
Ensure valves are closed (cold fully counterclockwise, hot
fully clockwise).
Turn on main water supply.
6. MAINTENANCE
CERAMIC VALVE REPLACEMENT
Remove all handle components per instructions for
handles purchased separately. Be careful not to scratch
plated surfaces.
Remove existing valve. Thread new ceramic valve into
valve body until hand-tight. Use torque wrench to tighten
valve to 23-30 ft. lbs. (31-41 Nm) If torque wrench is not
available, tighten to 1/8 turn past hand-tight.
CAUTION: Risk of product damage. Overtightening
may damage ceramic valve and result in internal
leakage.
Reinstall handles using instructions packed with handles.
CALL US FOR HELP
Questions? Problems? First review the installation instruction to ensure correct installation. For additional
assistance, call our Customer Service Department for direct help. You may also contact us at our web site listed
below.
Kohler Co., Kohler, WI U.S.A.
In the U.S.A., call 1-800-4-KOHLER
In Mexico, call 001-877-680-1310
In Canada, call 1-800-964-5590
www.kohler.com
7
3/8" Pipe Plug
CLOSE
HOT
Fig. #13
REMOVE
Fig. #14
CLOSE
COLD
INSTALL
Ceramic Valve
A
1013511-2-