Care And Maintenance - Daitsu APD12-AN Manual De Usuario

Remove the air filter out
from the grille
Band
Power cord
51

CARE AND MAINTENANCE

Air filter
(slide out)
Fig. 26
Remove three
screws and take
the air intake
grille down
Fig. 27
Fig. 28
Fig. 29
Fig. 30
IMPORTANT
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
manufacture or its agency.
1. Air filter:
- Clean the air filter at least once every two weeks to
prevent inferior fan operation because of dust.
- Removal
This unit has two filter. Grasp the upper filter tab (Fig.26),
pull the filter out then up . Remove the lower filter by
loosening the screws, taking down the air inlet grille, then
removing the air filter as shown in Fig.27 & 28.
- Cleaning
Wash the air filter by immersing it gently in warm water
(about 40ºC/104ºF) with a neutral detergent. Rinse the
filter and dry it in a shady place.
- Mounting
Insert the upper air filter from upward after cleaning,
attach the lower air filter to the air inlet grille, then install
the grille by using the screws. Make sure the screws are
securely fastened.
2. Unit enclosure:
- Use a lint-free cloth soaked with neutral detergent to clean
the unit enclosure. Finished by a dry clean cloth.
3. Unit idle for a long time:
- Remove the rubber plug at the back of the unit and
attach a hose to drain outlet. Place the open end of the
hose directly over the drain area in your basement floor
(See Fig.23-24).
- Remove the plug from the bottom drain outlet, all the
water in the bottom tray would drain out (See Fig.25).
- Keep the appliance running on FAN mode for half a day
in a warm room to dry the appliance inside and prevent
mold forming.
- Stop the appliance and unplug it, wrapped the cord and
bundle it with the tape (Fig.29). Remove the batteries
from the remote controller.
- Clean the air filter and reinstall it.
- Unscrew the exhaust hose to the right or left and pull out
for uninstallation (Fig.30), keep it safety or place behind
the air intake grille, and cover the window (wall) hole with
the adaptor cap.