Operating Instructions - Daitsu APD12-AN Manual De Usuario

• ION button (optional)
Press the ION button, the ion generator is
energized and will help to remove pollen and
impurities from the air, and trap them in the filter.
Press it again to stop the function.

OPERATING INSTRUCTIONS

COOL operation
- Press the MODE button until the COOL indicator
light comes on.
- Press the ADJUST buttons "" or ""to select
your desired room temperature. The temperature
can be set within a range of 17ºC-30ºC/62ºF-
88ºF.
- Press the FAN SPEED button to choose the fan
speed.
HEAT operation (cooling only models without)
- Press the MODE button until the "HEAT"
indicator light comes on.
- Press the ADJUST buttons "" or "" to select
your desired room temperature. The temperature
can be set within a range of 17ºC-30ºC/62ºF-
88ºF.
- Press the FAN SPEED button to choose the fan
speed. For some models, the fan speed can not
be adjusted under HEAT mode.
DRY operation
- Press the MODE button until the DRY indicator
light comes on.
- Under this mode, you cannot select a fan
speed or adjust the temperature. The fan motor
operates at LOW speed.
- Keep windows and doors closed for the best
dehumidifying effect.
- Do not put the duct to window.
AUTO operation
- When you set the air conditioner in AUTO mode,
it will automatically select cooling, heating
(cooling only models without), or fan only
operation depending on what temperature you
have selected and the room temperature.
- The air conditioner will control room temperature
automatically round the temperature point set by
you.
- Under AUTO mode, you can not select the fan
speed.
45
• SWING button
(Applicable to the models with auto swing
feature only)
When the operation is ON, press the SWING
button can stop the louver at the desired angle.
The louver swing up to an angle of 6 for each
press. Keep pressing the button more than 2
seconds can initiate the auto swing feature.
FAN operation
- Press the MODE button until the FAN indicator
light comes on.
- Press the FAN SPEED button to choose the fan
speed. The temperature cannot be adjusted.
- Do not put the duct to window.
TIMER operation
- When the unit is on, first press the Timer button,
the TIMER OFF indicator light illuminates. It
indicates the Auto Stop program is initiated.
- When the unit is off, first press the Timer button,
the TIMER ON indicator light illuminates. It
indicates the Auto Start program is initiated.
- Press or hold the UP or DOWN button to change
the Auto time by 0.5 hour increments, up to 10
hours, then at 1 hour increments up to 24 hours.
The control will count down the time remaining
until start.
- The selected time will register in 5 seconds
and the system will automatically revert back to
display the previous temperature setting.
- Turning the unit ON or OFF at any time or
adjusting the timer setting to 0.0 will cancel the
Auto Start/Stop timed program.
- When the malfunction (E1 or E2) occurs, the
Auto Start/Stop timed program will also be
cancelled.
SLEEP operation
Press this button, the selected temperature will
increase (cooling) or decrease (heating) by 1ºC /
2ºF in 30 minutes. The set temperature will then
increase (cooling) or decrease (heating) by another
1ºC / 2º after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
returns to the originally selected temperature. This
ends the Sleep mode and the unit will continue to
operate as originally programmed.
NOTE: This feature is unavailable under FAN or
DRY mode.