Cap 5 Maintenance; General Rules; Cleaning; Cleaning The Filter Unit - Eurofred 7FEB0015 Manual De Instrucciones

UK
Before doing any maintenance, completely drain out all water, shut off the power supply and close
the water supply cock.
Do not use water under pressure - it can damage the electrical equipment.
Only wash the body panelling when it is cold, using only product specifically designed for steel.
If there is a risk of ice forming, drain the water from the boiler and wash pump.
To keep the machine in good working order, it must be
maintained regularly
recommend periodically running a sanitising treatment
with suitable non-corrosive commercial products.
5.3
Run this procedure at the end of the day or when you see
the filters are dirty:
1. Remove and clean the baskets.
2. Empty out the tub as explained in "Machine
draining".
3. Remove and carefully clean all the filters.
4. Do not use abrasive products to clean the tub.
5. Restore all removed parts when finished.
The machine is equipped with a self-diagnosis system that registers and warns of a number of malfunctions via the
fast-flashing LEDs. The table below described the malfunctions recorded


Power LED

Cycle LED
WARNING! Switching the dishwasher off and then on again "resets" the signals, if after carrying out the instructions
given the problem persists, contact an Authorised Service Centre.
Page 8 of 10
DISHWASHER INSTRUCTION MANUAL
5.2

Cleaning

as explained below.

Cleaning the filter unit

Electro-mechanical safety device.
Power Led flashes quickly.
The boiler or tub safety thermostats have cut in, or the tub level safety pressure switch
has been triggered. Check that the drain is not blocked. Switch the dishwasher off and
then on.
Water filling in tank fault.
Power and Cycle Leds flash quickly.
The tank has not filled correctly. Check the water supply and/or the presence of the
overflow. Switch the dishwasher off and then on and fill again.
Rinsing temperature reset fault.
Cycle Led flashes quickly (only dishwashers with thermal – stop on).
The boiler temperature did not reset in the set time during the washing cycle. Switch the
machine off and then on and run a new cycle.
We
The wash and rinse arms are easily removed in order to
clean their nozzles and prevent blockage/encrustations.
Proceed as follows:
1. Undo nut and remove the arms.
2. Wash all parts under a jet of running water and
clean the nozzles thoroughly, using a toothpick or
pointed tool if necessary.
3. Clean the arm rotation pins inside the machine and
the wash and rinse water drainage area.
4. Restore the arms and check that they rotate freely.
Cap 5
MAINTENANCE
5.1

General rules

5.4

Cleaning the arms

Cap 6
SELF-DIAGNOSIS