Cap 3 Risks And Important Warnings; Normal Operating Conditions - Eurofred 7FEB0015 Manual De Instrucciones

DISHWASHER INSTRUCTION MANUAL
 This appliance is intended solely for the use for which it was designed. Any other use is improper
and therefore hazardous.
 The specialised technician responsible for installing the appliance must instruct the user on its
operation and any attendant safety measures, including practical demonstrations.
 Only the manufacturer or an authorised service centre with qualified staff may work on the
machine, even in case of malfunction, using only original spare parts.
 Always disconnect or isolate the machine from its power and water supplies before servicing,
repairing or cleaning it.
 The machine may NOT be used by persons untrained in its use.
 The machine may NOT be left powered up when not in use.
 NEVER open the machine quickly if it has not completed its cycle.
 NEVER use the machine with its guards removed.
 NEVER use the machine to wash objects of any form, size or material not guaranteed to be
machine-washable or not in good condition.
 NEVER use the machine or any of its assemblies as steps or support for persons, property or
animals.
 NEVER overload the open door of front-loading machines, which is rated only to support the
basket loaded with dishes.
 NEVER place your bare hands in the wash solution.
 NEVER overturn the machine after it has been installed.
 If you notice any malfunction or fluid leak, immediately disconnect the power supply and shut off
the water supply.
 Do not install the dishwasher in the vicinity of heat sources over 50°C.
 NEVER leave the dishwasher exposed to the weather (rain, direct sunlight, etc.)
 The dishwasher may not be installed outdoors without proper cover.
 Never start a wash programme without the overflow in the tub (as applicable).
 Never place magnetic objects in the vicinity of the machine.
 Do not use the top of the machine as a table or support.
 The installer is responsible for checking that the grounding system is fully operational.
 At the end of testing, the installer must issue a written declaration stating that the machine has
been installed and tested in accordance with established legislation and good practice.
 DO NOT change the position or tamper with the machine parts, such operations could
compromise the machine safety.
 Weighted sound pressure level LpA ≤ 70 dB(A).
Ambient temperature: 40°Cmax /4°Cmin (average 30°C)
Altitude
Relative humidity
Cap 3
: up to 2000 metres
: Max 30% at 40°C / max 90% at 20°C
RISKS AND IMPORTANT WARNINGS

3.1 Normal operating conditions

UK
Page 5 of 10