Water Circuit Hookup; Rinse Aid And Detergent; Connection To The Drain Line; Dosing Unit Settings - Eurofred 7FEB0015 Manual De Instrucciones

UK

2.4 Water circuit hookup

 The appliance must be connected to its
water supply with a flexible hose. A shut off
valve (cock) must be installed between the
water supply line and the appliance's
solenoid valve. The cock must be close to
the appliance.
The water supply,

pressure must be compatible with the
ratings on the machine's nameplate.
 If the hardness of the water is greater than
14 F (8 dH), we recommend using an
internal water
request). If the hardness of the water is
greater than 35 F (19.5 dH), install and
external water softener upline of the
solenoid valve.
If the water has a very high residual

concentration of high conductivity minerals,
we recommend installing a demineralisation
system.

2.5 Connection to the drain line

 The drain line must consist of a free drain
sump with siphon suited to the flow capacity
of the drain hose supplied with the
appliance. The hose must be able to reach
the sump without stretching, restriction,
folding, crushing, pressing or forcing in any
way.

The tub drains under gravity, so the drain
sump must be lower than the machine's
base.
 if the drain is not lower than the base of the
appliance, you can use the version with
drain pump (available on request).
 In this case, the drain connection may be no
higher than 1 m.
 Always check that the drain works properly
and is not blocked.

Any other solution must be approved by the
manufacturer in advance.
Page 4 of 10
DISHWASHER INSTRUCTION MANUAL
temperature and
softener (available

2.6 Rinse aid and detergent

 The rinse aid and detergent are dispensed
by the
(depending on model).
 The dose is set by the installer in relation to
the hardness of the water, and he also
calibrates the dispensers themselves.
Before calibrating them, fill the dispenser

supply tubes with their respective product.
 The level of fluid in the container must be
sufficient for priming; do not allow it to drain
completely or top it up with corrosive or
on
impure product.
NEVER use CHLORINE or HYPOCHLORITE
based detergents.
We recommend
detergent dispenser.
If the machine is equipped with dosing units, the settings
can be changed as follows:
 Machine in standby with door open.
 Hold down both the DRAIN (3) and START (4)
buttons.
 The CYCLE LED (6) will start flashing, thereby
indicating the machine is in programming mode.
 Press the START button (4) to adjust the
DETERGENT dosing time; each press of the
button is equivalent to one second. The POWER
LED (5) will flash at each press.
 Press the DRAIN button (3) to adjust the RINSE
AID dosing time; each press of the button is
equivalent to one second. The HEATING LED (7)
will flash at each press.
 Close the door and turn on the machine by
pressing the ON-OFF button (1), to save the
settings.
Each time the machine enters programming mode,
these settings will be erased.
machine's integral
installing an

2.7 Dosing unit settings

dispenser
automatic