Removing The Integral Filter (Optional); Resin Regeneration (Optional); Emptying The Dishwasher; Turning The Dishwasher Off - Eurofred 7FEB0015 Manual De Instrucciones

DISHWASHER INSTRUCTION MANUAL
4.5

Removing the integral filter (optional)

 Move the washing and rinsing arms at right angles
to the edge of the door.
 Lift each semi-filter by the relative handle.
4.6

Emptying the dishwasher

Appliances with no drain pump
 Switch the dishwasher off.
 If present, remove the integral filter.
 Pull up and remove the overflow pipe.
 Wait for the tub to empty completely.
 If necessary, extract the tub filter and clean
Appliances with drain cycle (*optional)
 Switch the dishwasher off.
 If present, remove the integral filter.
 Pull up and remove the overflow pipe.
 Close the door.
 Press the DRAIN (3) button for a few seconds to
start the cycle;
 The drain cycle is shown by the POWER (5) led
coming on and the CYCLE UNDERWAY (6) led
flashing.
 The machine runs a drain cycle and then switches
off.
 If necessary, extract the tub filter and clean.
4.7

Turning the dishwasher off

 Press the ON/OFF button (1), the POWER LED (5)
will continue to flash indicating that power is being
supplied.
4.8

Resin regeneration (optional)

In machines with internal water softener, a regeneration
cycle should be run periodically to ensure the correct
operation of the softener. The number of cycles
between one resin regeneration and the next depends
on the hardness of the local water, and should be set in
accordance with the following table.
No.
dH °F
Cycles
6 10 160
7 12 150
8 14 140
9 16 130
10 18 120
11 20 110
12 21 100
Proceed as follows:
 Switch the dishwasher off
 Empty and clean it.
 Remove the integral filter and open the salt
container in the tub.
 Pour in 250-300g of regeneration salt (1 or
2mm grain size kitchen salt with no additives).
 Close the container firmly.
 Make sure the overflow has been removed.
 To start the cycle, with the machine off press
START (4) for a few seconds.
 The cycle is shown by the POWER (5) led
coming on and the CYCLE UNDERWAY (6) led
flashing.
 The regeneration cycle lasts around 20
minutes.
 The dishwasher will switch off when the cycle
has completed.
N.B. Do not switch the machine off during the
regeneration cycle
4.9

End of shift

 At the end of the day always drain the machine
as described in the section "Emptying the
dishwasher".
 Disconnect the power supply by means of the
main switch and close the external water cock.
 Perform routine maintenance and clean the
machine as described in the section
"Maintenance".
If possible, leave the door ajar to prevent bad odours
building up inside the machine.
UK
No.
dH °F
Cycles
13 23 90
14 25 80
15 27 70
16 29 60
17 30 50
18 32 40
19 34 30
Page 7 of 10