Altering An Option Or A Running Programme; Interrupting A Programme - AEG LAVAMAT 11842 VIT Manual De Instrucciones

14
Daily use
To interrupt a programme which is running, press the button 8: the corresponding red pilot
light starts blinking.
To restart the programme from the point at which it was interrupted, press the button 8
again.
If an incorrect option is selected, the yellow pilot light of the button 8 blinks for 3 times the
message Err is displayed for about 2 seconds.
Select the DELAY START (Button 9)
Before you start the programme, if you wish to delay the start, press the button repeated-
ly, to select the desired delay.
The selected delay time value (up to 20 hours) will appear on the display for about 3 sec-
onds, then the duration of the programme will appear again.
You must select this option after you have set the programme and before you press the
button 8.
The wash programme can be delayed from 30 min - 60 min - 90 min, 2 hours and then by 1
hour up to a maximum of 20 hours by means of this button.
The door will be locked throughout the delay time. If you wish to add laundry in the ma-
chine during the delay time you will press button 8 to put the machine in pause. Add the
laundry, close the door and press button 8 again.
Selecting the delayed start.
• Select the programme and the required options.
• Select the delay start.
• Press button 8: the appliance starts its hourly countdown. The programme will start after
the selected delay has expired.
Cancelling the delayed start
• Set the washing machine to PAUSE by pressing the button 8;
• Press button 9 once until the symbol
• Press the button 8 again to start the programme.
The selected delay can be changed only after selecting the washing programme again.
The Delay Start can not be selected with DRAIN programme.

Altering an option or a running programme

It is possible to change some options before the programme carries it out. Before you make
any change, you must pause the washing machine by pressing the button 8.
Changing a running programme is possible only by resetting it. Turn the programme selec-
tor dial to and then to the new programme position. Start the new programme by
pressing the 8 button again. The washing water in the tub will not emptied out.

Interrupting a programme

Press the button 8 to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.
All manuals and user guides at all-guides.com
' is displayed;