StetSom MOTO DUPLO i Manual De Usuario página 9

English
FUNCTION ON THE CONTROL AND RESPONSE OF THE ALARM
1
Press
Then
Then
Then
For
3 Secs.
Press
Twice (2x)
For
3 Secs.
For 3 Secs,
Then
1.1. ENABLE OR DISABLE PERIODIC TRANSMISSION (ONLY CX-1P)
The CX-1P control comes
from the factory with the
presence transmission
DISABLED. Before use,
make sure the presence
transmission is ENABLED.
If it is disabled, the lock
cycle will begin.
After use, it is recommended that the periodic transmission be disabled to extend
CR2032 battery life (It is recommended that the battery be replaced every 4 months).
When the ignition is turned on, the alarm will give 1 beep if the control battery is low.
Function
Enable the alarm
Disable the alarm
Enable the alarm
without sound
Disable the alarm
without sound
Panic function
Enable alarm wi-
thout accelerometer
Localization
Function
Available only in the TRIPLO i
Turn on the panel
Start Function
HOLD
THEN PRESS
...until the led turns off and
flash 1 time (ENABLE).
...until the led turns off and
flash 2 times (DISABLE).
9
Alarm Response
Blinkers flash once, siren beeps
once.
Blinkers flash twice, siren beeps
twice.
Blinkers flash once. (1x)
Blinkers flash twice. (2x)
Sets off the alarm for 30 secs
2 Beeps and blinkers flash 1
Blinkers flash for 15 secs
Turns on motorcycle's
15th line (Accessory position).
Starts the motorcycle
...
CX-1P