Alarm Functions - StetSom MOTO DUPLO i Manual De Usuario

PROGRAMMING CONTROLS
2
TURN ON
IGNITION
TURN OFF
IGNITION
If the control is already programmed the siren will emit 1 beep. Each time a new
control is programmed to the control panel the memory is cleared. Therefore all
existing controls must be reprogrammed with the new one or they will not work.

ALARM FUNCTIONS

3
3.1. TRIGGERED ALARM
When the alarm is triggered, it immediately locks down. The alarm sounds for one
minute, then waits 10 seconds and reads the sensors again. After the alarm has been
triggered ten consecutive times by the accelerometer, this sensor is ignored until the
next activation, unless the motorcycle is turned on.
3.2. USING THE CONTROL TO TURN ON THE MOTORCYCLE (ONLY MOTO TRIPLO i)
PRESS
FOR 3 SECS.
MOTORCYCLE TURNS ON
• Press button for 3 seconds. A beep will sound, the motorcycle's panel will be
activated, and if the
(gray wire, positive current). As long as the
• To turn on the ignition, the motorcycle must be in Neutral
• If you need to start the ignition again, press the
• To turn off the motorcycle press the
will turn off.
• If the motorcycle is in gear, it will not be switched off to prevent it from accidentally
turning off when in motion.
Before checking the control panel, give it 10 seconds after it has been activated to
stabilize all the sensors.
ENABLE OR DISABLE ALARM
4
The control panel can be switched on and off by programming (see table section 12,
function 2).
PRESS THE MASTER BUTTON
EMITS 3 BEEPS FOR EACH
PROGRAMMED CONTROL
SIREN EMITS
1 BEEP
button is pressed within 10 seconds the ignition will turn on
button, 2 beeps will sound and the motorcycle
AND
PANEL TURNS ON
AUTOMATICALLY
PRESS
button is held the output remains active.
button and then in 3 seconds
10
UNTIL THE SIREN
BEEPS
PRESS
TOGETHER
.
N
.