Setting The Meat Probe Options - Fulgor Milano SOFIA Manual De Uso

11 - Setting the Meat Probe Options

EN
This oven is provided with the meat probe feature to sense the
temperature inside meat and stop cooking as soon as the set
value is reached.
The following modes can be selected to work with the meat
probe:
CONVECTION BAKE
CONVECTION ROAST
BAKE
Other modes are not allowed to start if the probe is inserted .
(F13 error code appears).
Once the probe has been inserted in its receptacle and
detected by the control, turn the cooking mode knob into a
valid position, the PROBE text appears on the cooking mode
display along with the selected function.
The meat probe standard temperature (170°F) flashes on the
clock module for 5 seconds.
+
Using the / - keys, it's possible to change the probe set.
The standard probe temperature set-point is 170°F.
The allowed range is between 130°F and 210°F. The maximum
cavity temperature during cooking with meat probe is 475°F.
The resolution must be 5°F or 2.5°C both for set and actual
temperature.
After 5 seconds the value on the display is accepted and the
control starts cooking. The actual probe temperature is now
shown on the timer display.
16
+
Touch or once to check the probe set temperature.
-
When it's flashing touch it again or hold to modify the value.
As soon as the set probe temperature is reached, the control
beeps indicating the end of cooking and stops the oven.
Always turn the cooking mode to the OFF position after a
particular cooking mode has automatically turned off the oven
so it is properly reset for the next time it is used.
The PROBE text flashes when the mode is not valid for cooking
with probe. If the probe is removed during cooking, or in case
of a short or open circuit, a fault message will be displayed.
Automatic time functions are disabled when using the meat
probe, only the timer can work.