Storage; Troubleshooting - Schumacher Electric XP2260 Manual Del Usuario

6.

STORAGE

IMPORTANT:
• CHARGE IMMEDIATELY AFTER PURCHASE
• KeeP FuLLy ChARGeD
Charge the Instant Power™ internal battery immediately after purchase, after
every use and every 30 days.
All batteries are affected by temperature. The ideal storage temperature is
at 70 degrees Fahrenheit. The internal battery will gradually self-discharge
(lose power) over time, especially in warm environments. Leaving the battery
in a discharged state may result in permanent battery damage. To ensure
satisfactory performance and avoid permanent damage, charge the internal
battery every month.
The clips on the Instant Power™ are live and will produce arcing or sparking
if they come in contact with each other. To prevent accidental arcing, always
keep the clips on the storage holders when not using it to jump start a vehicle.
7.

TROUBLESHOOTING

PROBLEM
The Instant Power™ won't Jump Start/USb Switch is
jump start my car. not turned ON.
Clips are not making a good
connection to the battery.
Connections are reversed.
The Instant Power™ battery
is not charged.
The vehicle's battery is
defective.
The Instant Power™ won't The 12V device is not
power my 12V device. turned on.
The Instant Power™ battery
is not charged.
The 12V device draws more
than 15A or has a short
circuit
All manuals and user guides at all-guides.com
POSSIBLE CAUSE REASON/SOLUTION
Turn ON the Jump Start/
USb Switch.
Check for poor connection
to battery and frame. Make
sure connection points are
clean. Rock clips back and
forth for a better connection.
Disconnect the Instant
Power™ and reverse the
clips.
Check the battery charge
status by pressing the button
on the front of the Instant
Power™. See DIgITAL
DISPLAY FUNCTIONS
section of this manual.
have the battery checked.
Turn on the 12V device.
Check the battery charge
status by pressing the button
on the front of the Instant
Power™. See DIgITAL
DISPLAY FUNCTIONS
section of this manual.
Disconnect the 12V device.
The internal breaker will
automatically reset after a
minute or two. Try the 12V
device again. If it happens
again, replace the 12V
device.
11
• •