Orbegozo CU 7000 Manual De Instrucciones página 10

CU 7000
USE
BEFORE FIRST USE
When you unwrap the appliance, ensure to remove all the packaging. Clean the appliance with a damp cloth.
VERY IMPORTANT: it is not recommended to use the sharpener for more than 3 minutes continuously. After
this operation, switch it off and let it rest for 20 minutes, so it will cool.
HOW TO SHARPEN A KNIFE
STEP 1. Grinding: the first step is making a grinding blade.
Plug into the mains supply and press the switch. Should place the knife in the grinding zone, in the slot A of
picture, the handle of the knife should be as close to the slot. Lower the knife slowly to avoid blocking the
rotation of the wheel and pull the knife down to the tip, do it the same placing the knife in the slot B of the
picture. Repeat these operations 3 or 4 times, or until you see that the edge angle and the grinding is entirely
uniform along the entire blade.
IMPORTANT: Should start pulling of the handle to you as soon as insert the blade into the slot. Make sure the
pressure applied on the handle is enough to keep the blade in contact with the grinding wheel without
actually stopping the rotation of the motor.
STEP 2. Sharpening: the second step is making sharpening blade.
Should place the knife in the sharpening zone, in the slot C of the picture, the handle of the knife should be
as close to the slot. Lower the knife slowly to avoid blocking the rotation of the wheel far as the plastic stop,
then pull the knife slowly watching the grinding wheel is not locked so go sharpening evenly around the
edge to reach the tip. Do the same in slot D shown in picture. Repeat these operations 3 or 4 times, or until
you verify that the edge is completely uniform throughout the blade and on both sides.
HOW TO SHARPEN SCISSORS
- Plug to the mains supply and pulse the switch.
- Open the scissors and hold it by the edge.
- Put the finer side up, insert the scissors into the slot that puts "scissors" (F in picture) and when you feel it
touch the wheel pull them toward you keeping pressure on the wheel (without blocking).
- Can adjust the angle between the scissors and the wheel according the thickness and size of scissors
slightly.
- Sharpening the other blade in the same way.
- When you finish, switch off and unplug the sharpener.
HOW TO SHARPEN A SCREWDRIVER
- Plug the sharpener and switch on.
- Hold the screwdriver by the handle and the tip in the grinding slot (A or B in picture) to repair the
deformed tip on each side (one to one).
- Then insert the tip in the square hole of the right, where you read "screwdriver", so you can grind the
peak of screwdriver.
- After this process switch off and unplug the sharpener.
HOW TO USE THE AUTO REWIND FUNCTION
- Pull the cord to the length needed to connect the sharpener to the mains supply when using it.
10