Replacing Monitor Cables; Disposal - Stryker OR Instrucciones De Uso

Replacing Monitor Cables

To replace a monitor cable (monitor power cable, HDMI cable, DVI cable):
1. Disconnect the cart from supply mains.
2. Disconnect the cable to be replaced from inside the cart and from the
monitor.
3. Using a 3/8" nut driver, remove the cable housing from the underside
of the top of the cart.
4. Pull the disconnected cable(s) up through the cable port in the top of the
cart, removing any rubber grommets as necessary.
5. Remove the Cable Manager from the arm.
6. Using a 3/32" hex key, remove the top cover on the radial
section of the arm (as shown).
7. Remove the cable to be replaced from the arm.
8. Install the replacement cable in the arm as shown and reinstall the top cover.
9. Route the replacement cable down through the top cable port and reconnect it inside the cart.
10. Reinstall the cable housing to the underside of the top of the cart.
11. Reconnect the cables to the monitor.

Disposal

All Connected OR Cart components shall be disposed of in compliance with local, regional and national regulations.
Do not dispose any part in general waste.
14 EN P44082 Rev. D