Maintenance And Service; Maintenance And Cleaning - Bosch GKS 190 Professional Instrucciones De Servicio

0°
— Tighten wing bolt 7 to lock the position of the
guide-rail adapter.
— Remove the circular saw with the premount-
ed guide-rail adapter 27 from the guide rail
28 .
— Align the guide rail 28 on the workpiece in
such a manner that the rubber lip lies exactly
alongside the cutting edge.
— The guide rail 28 must not extend beyond
the face side of the workpiece where the
cut is to be started.
— Fasten the guide rail 28 with suitable clamp-
ing devices, e. g., screw clamps, on the work-
piece. Set the circular saw with the pre-
mounted guide-rail adapter 27 on to the
guide rail.
— Switch the machine on and guide it in the
cutting direction applying moderate and
steady feed.
Two guide rails can be connected to one with
use of the connection piece 29 . Clamping is car-
ried out with the four screws located in the con-
nection piece.
Bosch Power Tools
3_GKS190_Page5to40.indd 39 3_GKS190_Page5to40.indd 39

Maintenance and Service

Maintenance and Cleaning

1- 45°
The retracting blade guard must always be able
to move freely and retract automatically. There-
fore, always keep the area around the retracting
blade guard clean. Remove dust and chips by
blowing out with compressed air or with a
brush.
Saw blades that are not coated can be protect-
ed against corrosion with a thin coat of acid-free
oil. Before use, the oil must be removed again,
otherwise the wood will become soiled.
Resin and glue residue on the saw blade produc-
es poor cuts. Therefore, clean the saw blade im-
mediately after use.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2-wire cable.
The wires in the cable are coloured according to
the following code:
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this power tool, it
must be disposed of safely.
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
F 000 622 290 | 04.2009
English | 39
17.04.09 16:58:24 17.04.09 16:58:24