Rear Panel - Sanyo DSR-M810P Manual De Instrucciones

2 NAMES AND FUNCTIONS OF PARTS

Rear panel

10
1. FAN
2. AUDIO IN terminal
3. AUDIO OUT terminal
4. LAN terminal ( P.39)
5. MIC IN terminal
6. VIDEO IN terminal
7. VIDEO LOOP OUT terminal
8. VIDEO OUT terminal
9. TV SYSTEM selector switch
Used to select the video signal between NTSC and PAL
systems for the camera input and TV monitor output
connected to the digital video recorder.
Turn the power OFF then ON again after switching the
TV SYSTEM selector switch to NTSC or PAL.
10. Power cord holder
Secure the power cord to the holder using the cord tie
(accessory) as shown in the illustration.
Cord tie
11. AC INLET
AC power input terminal (3-core)
All manuals and user guides at all-guides.com
1 2 3
AUDIO LAN
IN OUT
TV RS485
SYSTEM TERMINATE
NTSC ON
PAL OFF
11 9 12
8
4 5 6 7 8
VIDEO
MIC IN IN LOOP OUT OUT
NON REC OUT/
SERIES REC OUT ALARM IN
ALARM RESET
CLOCK
SERIES
RS485 REMOTE ADJ ALARM OUT
REC IN
WARNING OUT
FULL OUT
A B C C IN OUT C
ALL
RESET
13 14
12. RS-485 TERMINATE switch ( P.48)
RS-485 termination ON/OFF switch
13. Control and alarm terminals
Pin
RS-485A To RS-485 terminal signal A *
RS-485B To RS-485 terminal signal B *
C Common *
REMOTE For wired remote control (VA-RMN01)
C Common
CLOCK ADJ IN Input for clock setting
CLOCK ADJ OUT Output for clock setting
SERIES REC IN SERIES-REC input
NON REC OUT/ NON-REC output/
SERIES REC OUT SERIES-REC output *
ALARM IN Alarm input
ALARM RESET Alarm reset input
ALARM OUT Alarm output
C Common
WARNING OUT Warning output *
FULL OUT Recording area full warning
1
* Use a twisted-pair cable for connection.
2
* NON REC is output when SERIES REC OUT is OFF.
3
* The following warnings are output:
Hard disk drive error Fan error
No input signal when VIDEO LOSS is ON.
14. ALL RESET switch
Resets the clock and backup mode setting.
Signal
1
1
1
2
3
Recording error
English