Adjusting The Cutting Height - Bosch ROTAK 32 Instrucciones De Servicio

GB • Printed in England • BA F 016 L69 834 • ROTAK 32/34/34 C • GB • OSW 09/01
F016 L69 834.book Seite 3 Dienstag, 18. September 2001 8:42 08
For products not sold in GB:
WARNING: For safety, it is essential that the mains
plug 4 attached to the machine is fitted to the power
supply cable 12. (see figure
The couplings of connection leads must be pro-
tected against splashes and the coupling sockets on
the leads must be made of rubber or coated with
rubber.
Fixing means for the connection leads must be
used.
The connection lead must be inspected for signs of
damage at regular intervals and may only be used if
in perfect condition.
If the supply cord is damaged, it must be replaced by
a Bosch Service Center.
Products sold in GB only: Your mower is fitted with
an approved 13 A (BS 1363/A) electric plug and is
protected by a 13 A fuse (ASTA Approved to
BS 1362).
If the fitted plug is not suitable for your socket out-
lets, it should be cut off and an appropriate plug fit-
ted in its place.
The severed plug must be disposed of to avoid a
possible shock hazard and should never be inserted
into a 13 A socket elsewhere.
Assembly
A
(see figure )
Insert the handle bottom 8 into the holes provided
and
secure with the screws.
Attach the handle top 3 with the bolts and wing
nuts 13 to the handle bottom 8.
Note: Ensure that the cable clips supplied are used
to fix the cable to the handle.
Attach cable to cable restraint 5 ensuring that suffi-
cient cable slack is available. (see figure
Snap together both top and bottom half of the grass-
box.
Ensure the cable is not trapped when folding/unfold-
ing top handle. Do not drop the handles.
14 • F016 L69 834 • TMS • 14.09.01
Fitting
B
)
Lift the deflector guard 7 and hold up, fit the grass-
box 6.
Removing/Emptying
Lift the deflector guard 7 and hold up. Remove
grassbox 6.
For non grass collection the mower can be used
without the grassbox 6 in position, with the deflector
guard 7 in the down position.
For the first cutting of the season, a high cutting ad-
justment should be selected.
ROTAK 32 (see figure
Your machine has three settings that result to the
following cutting heights.
I = 20 mm
Remove the grassbox to aid adjustment (see Grass-
box).
Lift the mower,
Make sure that all wheels are set to the same height.
ROTAK 34/34 C (see figure
The lawnmower can be set to 11 cutting heights be-
tween 20 and 70 mm. For this purpose, press the
)
B
height-of-cut lever 11 outwards and move the lawn-
mower up or down until the desired cutting height is
adjusted.
English - 3
Grassbox (see figure

Adjusting the Cutting Height

Stop, release switch lever and wait until
the motor stops before adjusting height.
The blades continue to rotate after the ma-
chine is switched off, a rotating blade can
cause injury.
C )
II = 40 mm III = 60 mm
pull/push the wheel to the front of the mower us-
ing the hand positioned on the wheels.
Raise/lower the wheel.
Allow wheel to locate in desired position.
)
F
D
)