Measuring Range - Powerfix Profi HG00384C Instrucciones De Utilización Y De Seguridad

and the previously selected material (1–6)
appears.
Press the
approximately 5 seconds to switch the tem-
perature display between °C and °F.
If the display does not show ‚0.0 %' after
switching it on, you can calibrate the device.
Do this as follows:
Open the battery compartment
the batteries and press the RESET button with
a pointed object, this button is on the bottom
of the device in the middle.
Press the MODE button
moisture measuring device to the material
you wish to measure.
Number Material
1
2
3
4
5
6
Note: When measuring under the measure-
ment range, the display shows ‚0.0%' or
‚Lo'. For measurements above the measure-
ment range, the display shows ‚Hi'.
button
4
Beech, spruce,
larch, birch,
cherry tree,
walnut tree, oak,
pine, maple, ash,
Douglas fir
Cement screed,
concrete, plaster
Anhydride screed
Cement mortar
Lime mortar
Brick
and hold it down for
, remove
6
again to set the
3
Measuring
range
6–44 %
1.4–7.4 %
0.0–4.1 %
0.8–5.1 %
0.4–3.7 %
0.0–8.5 %
GB/MT 49