Rollers Do Not Turn; Removing The Handle From The Basic Unit; Technical Specifications - Kärcher EWM 2 Manual Del Usuario

Rollers do not turn

Rollers are blocked.  Remove rollers and check if an object has become
stuck in the rollers.
 Check that the rollers are screwed in as far as they
will go onto the roller holder.
 Check that the floor head cover is correctly seated.
For this, remove the cover and then fit it back in
place.
Water vacuuming not optimum
Floor head cover not installed correctly
 Check that the floor head cover is correctly seated.
For this, remove the cover and then fit it back in
place.
The rollers are worn out.
 Replace the rollers.
Appliance is leaking waste water.
Waste water tank is overfilled.
 Empty the waste water tank right away.
Waste water tank does not fit properly in the appliance.
 Check that the floor head cover is firmly seated on
the waste water tank.
 Check that the waste water tank flaps are correctly
closed.

Removing the handle from the basic unit

ATTENTION
Do not remove the handle from the basic unit once it has
been assembled.
The handle may only be removed from the basic unit if
the unit is sent out for service purposes.
Illustration
See illustration at the end of the operating instructions
 Insert screwdriver at a 90 degree angle in the small
opening at the rear side of the handle and remove
handle.
ATTENTION
Please ensure that the connection cable between the
basic unit and the handle are not damaged.
Pull carefully to avoid damaging the device.

Technical specifications

Electrical connection
Voltage
Protection class
Device
Protective class
Charger protection class
Rated power of appliance
Nominal battery voltage
Battery type
Operating time with full charge
Charging time for empty battery
Charger initial voltage:
Output current, charger
Performance data
Roller revolutions per minute
Filling quantity
Fresh water tank
waste water tank
Dimensions
Weight (without accessories and
cleaning fluids)
Length
Width
Height
Subject to technical modifications!
– 12
EN
100-240 V
1~50-60 Hz
IPX4
III
II
40 W
7,2 - 7,4 V
Li-Ion
20 min
4 h
9,5 V
0,6 A
500 rpm
360 ml
140 ml
2,4 kg
305 mm
226 mm
1220 mm
19