Description Of The Appliance; Charging Process - Kärcher EWM 2 Manual Del Usuario

CAUTION
 Create stability for the appliance prior to any work
on or with the appliance to prevent accidents or
damage.
 Never fill solvents, solvent-containing liquids or un-
diluted acids (e.g. detergents, petrol, paint thinner,
and acetone) into the water reservoir as these sub-
stances corrode the materials used in the appli-
ance.
 Never leave the appliance unattended as long as it
is in operation.
 Keep parts of the body (e.g. hair, fingers) away
from the rotating cleaning rollers.
Protect your hands when cleaning the floor head

due to a danger of injury from sharp objects (e.g.
splinters).
 Keep connection cable away from heat, sharp edg-
es, oil and moving parts.
ATTENTION
 Only switch on the appliance when the fresh water
tank and waste water tank are fitted.
 The device may not be used for vacuuming sharp
objects or large objects (e.g. glass shards, gravel,
toy parts).
Do not fill the fresh water container with vinegar,

decalcification agents, essential oils or similar sub-
stances. Also take care to ensure that these sub-
stances are not vacuumed.
 Only use this appliance on hard floors with water-
proof coatings (e. g. varnished parquet, enamelled
tiles, Linoleum).
 Do not use the appliance for cleaning of carpets or
carpeted floors.
 Do not use the appliance over the floor grilles of
convector heaters. The appliance is not able to
take in the water discharged when used above
grilles.
 In case of longer breaks in operation and after use,
switch off the device at the main switch / device
switch and pull the charger's mains plug.
Do not operate the appliance at temperatures be-

low 0 °C.
 Protect the unit from rain. Do not store outside.

Description of the Appliance

1 ON/OFF switch
2 Handle
3 Wall anti-slip handle
4 Fresh water tank
5 Fresh water tank recessed grip
6 Charging socket
7 Waste water tank
8 Recessed grip cleaning roller
9 Cleaning rollers
10 Floor head cover
11 Floor head cover lock
12 Battery indicator
13 Charger with charging cable
14 Parking station
15 Roller storage
16 * Detergent RM 536 30 ml
EN
17 ** Detergent
18 ** Detergent
9 ** Cleaning rollers
* EWM 2
** EWM 2 Premium
Assembly
ATTENTION
Take care to ensure that the power cable lies fully in the
guide rail before fitting the handle bar.
Illustration
 Insert handle into the basic unit as far as it goes un-
til it engages audibly.
The handle must sit snugly into the appliance.
Commissioning
Illustration
 Place the device in the parking station for safe stor-
age.
Installing the rollers
Illustration
 Screw the cleaning rollers onto the threaded rod up
to the mechanical stop.
 Pay attention to the colour-codes on the inside of
the roller and roller holder on the appliance (e.g.
blue should match up with blue).
 After the installation, check to ensure that the
cleaning rollers sit snugly.

Charging process

Illustration
 Plug the charging cable of the charger into the
charging socket on the device.
 Plug the mains plug of the charger into a power out-
let.
Illustration
 The LED indicator lights display the battery's cur-
rent charging state.
 All 3 LED indicator lights flash from bottom to top
when charging a completely empty battery.
 The lowermost LED lights up continuously when
the battery is 1/3 charged, the two upper LEDs con-
tinue to flash.
 When the battery is 2/3 charged, the two lower
LEDs light up continuously, the uppermost LED
continues to flash.
 After the battery has been fully charged, the 3 LED indicator lights will continue to light constantly for
60 minutes. After this time, the LED indicator lights
go out.
Illustration
 Once the battery is charged, pull the mains plug out
of the socket and the charging cable out of the
charging socket.
– 8
RM 534 30 ml
RM 536 500 ml
2x
15