Connect Electrodes To Lead Wires; Connect Lead Wires To Device - intensity TWIN STIM III Manual De Instrucciones

4.2 Connect electrodes to lead wires

Insert the lead wire connector into electrodes connector
(standard 0.08 inch female connection). Make sure no bare
metal of the pins is exposed.
Connection Cables
Caution:
Always use the electrodes with CE mark, or which are legally
marketed in the US under 510(K) listing.

4.3 Connect lead wires to device

1) Before proceeding to this step,
be sure the device is
completely turned OFF,
2) The wires provided with the
system insert into the jack
sockets located on top of the
device.
3) Holding the insulated portion
of the connector, push the plug
end of the wire into one of the jacks
(see drawing); one or
two sets of wires may be used.
4) This device has two output receptacles controlled by
Channel I and Channel 2 at the top of the unit. You may
choose to use one channel with one pair of lead wires or
both channels with two pairs of lead wires. Using both
channels gives the user the advantage of stimulating two
different areas at the same time.
CAUTION:
Do not insert the plug of the patient lead wire into any AC
power supply socket.
All manuals and user guides at all-guides.com
Transparent Film
21