POWERBOOST MODE
The green LED will illuminate when the appliance is in
POWERBOOST mode. The vacuum will operate at a higher
suction level to pick up debris that requires more power.
FILTERSENSE
Whenever a filter is blocked and needs cleaning, the red
LED in the handle will illuminate. Clean dust from filter
(See "Cleaning the Dust Bowl and Filter" section).
NOZZLE / ACCESSORIES
•
A crevice tool (4) is built into the nozzle (3). Extend the
crevice tool as shown in Figure D, until it clicks in place.
•
To shorten the crevice tool, depress the crevice tool
release button (5) as shown in Figure E and slide the
crevice tool into the nozzle.
ATTACHING THE PET HEAD (FIG. G)
•
Slide the nozzle ( 3 ) into the opening of the motorized
pet head ( 13 ), ensuring that the connectors ( 16 )
engage with the recesses ( 17 ). An audible click will
be heard.
DETACHING THE PET HEAD (FIG. H)
•
Push the motorized pet head release button ( 14 ).
•
Lift the main unit from the pet head ( 13 ).
REMOVING THE BEATER BAR FROM THE PET
HEAD (FIG. I)
•
Press the beater bar release button ( 18 ).
•
Lift the beater bar ( 19 ) up and out of the pet head.
•
The beater bar can now be freed from any hair and
accumulated debris.
DRY PICK UP
•
For everyday spills of dry material.
•
Do not fill the dust bowl (8) beyond the end of the
intake chute.
OPTIMIZING THE SUCTION FORCE
In order to keep the suction force optimised, the filters
must be cleared regularly during use.
EMPTYING AND CLEANING THE PRODUCT
REMOVING THE DUST BOWL AND FILTERS -
FIGURES J & K
WARNING: The filters are reusable and should be
cleaned regularly.
Press the dust bowl release button (9) as shown in the
insert of Figure J, then pull the dust bowl (8) straight off as
shown in Figure J.
•
While holding the dust bowl over a bin or sink, pull
out the filter (20) to empty the contents as shown in
Figure K.
•
To replace the dust bowl, push it back onto the
appliance until it clicks firmly into place.
All manuals and user guides at all-guides.com
CLEANING THE DUST BOWL AND FILTER
•
•
FOR A MORE THOROUGH CLEANING
•
•
•
•
•
•
•
IMPORTANT: Maximum dust collection will only be
obtained with a clean filter and an empty dust bowl. If dust
begins to fall back out of the product after it is switched off,
this indicates that the bowl is full and requires emptying.
•
•
SCENTED FILTER
BEFORE FIRST USE - remove bag from the scented
pre-filter. Reassemble per instructions above. When the
vacuum is turned on, the plastic scented filter will emit an
aroma to freshen the air.
•
•
•
•
NOTE: When the plastic scented filter no longer lets off
the aroma, it can be an indication that the filter needs to be
replaced. See below for information on replacement filters.
*HHVJ325 vacuums are supplied with a scented filter,
ENGLISH • 11
WARNING: Never use the appliance without the filters.
Optimum dust collection will only be achieved with
clean filters.
The dust bowl and filter can be washed in warm soapy
water.
Make sure the filter and the dust bowl are dry before
re-fitting.
Remove the dust bowl and filter assembly as
described above.
To separate the plastic filter (21) from the cloth filter (22),
twist the plastic filter in a counterclockwise direction and
lift it off of the cloth filter as shown in Figure L.
The dust bowls and filters can be washed in warm soapy
water. Allow to dry before placing back into the vac.
To replace the filters, slide the outer plastic filter over the
cloth filter.
Align the wings of the plastic filter with the slots in the
cloth filter and twist in a clockwise direction.
Place filters back into the bowl pressing firmly to ensure
a secure fit.
To replace dust bowl, place it back onto the handle until it
"clicks" firmly into position.
Wash the filters regularly using warm, soapy water
and ensure that they are completely dry before using
again. The cleaner the filter is, the better the product
will perform.
It is very important that the filter is correctly in position
before use
ADVERTENCIA:
Causes mild skin irritation
Toxic to aquatic life
Harmful to aquatic life with long lasting effects.
Dispose of contents/ containers to an approved waste
disposal plant.