Product Characteristics; Technical Data - YATO YT-55840 Manual De Instrucciones

PRODUCT CHARACTERISTICS

Sandblast cabinet is a table-top sandblasting tool. Sandblasting is the mechanical removal of rust and/or paint coatings from
objects using a jet of abrasive material (abrasive) ejected from the gun nozzle by means of a jet of compressed air. Since sand-
blasting takes place inside the sealed chamber, a dusting of the abrasive material is limited to a minimum. The correct, reliable
and safe operation of the tool depends on its proper use, therefore:
Read and keep this entire manual before the fi rst use of the tool.
The tool supplier shall not be liable for any damage resulting from failure to comply the safety instructions and recommendations
specifi ed in this manual.
ACCESSORIES
The unit is delivered disassembled and must be assembled according to the instructions given below before starting work. The
product is delivered with a blast gun, additional nozzles and a pair of protective gloves. Abrasive is not supplied with the tool.

TECHNICAL DATA

Parameter
Catalogue No.
Maximum pressure
Operating pressure
Air consumption
Outer dimensions
Working area dimensions
Maximum abrasive volume
Weight (without abrasive)
Noise level
- sound pressure L ± K
pA
- power L ± K
wA
Vibration Level a ± K
h
Lamp
Rated voltage
Rated power
Lamp power supply
Supply voltage
Rated frequency
Output voltage
Output current
SAFETY INSTRUCTIONS
Warning! Close and secure the door before starting work. Unsecured doors can cause serious injuries.
Warning! Disconnect the machine from the air and power supply before opening the lid and before performing any maintenance
works.
The abrasive and compressed air jets are hazardous. Never point the tool outlet towards people - abrasives or compressed air
can cause body trauma or other injuries. Injection of lubricant can cause necrosis or even loss of limb. In case of injection, seek
medical attention immediately.
Due to multiple hazards, read and understand the safety instructions before starting installation, operation, repair, maintenance
and alteration of accessories or when working in the vicinity of a pneumatic tool. Failure to do so may result in serious injury.
Pneumatic tools may only be installed, adjusted and assembled by qualifi ed and trained personnel. Do not modify the pneumatic
tool. Modifi cations can reduce effi ciency and safety, and increase the risk for the tool operator. Do not throw away the safety
instructions, they should be handed over to the tool operator. Do not use the pneumatic tool if it is damaged.
Operators and service personnel are required to receive appropriate training in the use and repair of the equipment.
It is forbidden to use any other gases instead of compressed air. The use of gases may lead to serious injury, cause fi re or explo-
sion. When connecting the tool to the compressed air system, consider the space required for the hose to avoid damaging the
hose or connectors.
Eff ective ventilation should be provided at the workplace. Lack of eff ective ventilation may result in health hazards, cause fi re or
explosion. The tool is not intended for use in explosive atmospheres. Use the tool away from heat sources and fi re as this may
O R I G I N A L
12
All manuals and user guides at all-guides.com
GB
Unit
[MPa]
[MPa]
[l/min.]
[mm]
[mm]
[l]
[kg]
[dB(A)]
[dB(A)]
[m/s 2 ]
[VDC]
[W]
[VAC]
[Hz]
[VDC]
[A]
I N S T R U C T I O N S
Value
YT-55840
0.82
0.27 – 0.82
424 – 707
585 x 485 x 494
580 x 480 x 350
6.5
17.5
63.5 ± 3
65 ± 3
< 2.5
12
8
230 – 240
50
12
0.667