Troubleshooting - Ryobi RY40805 Manual Del Operador

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
PROBLEM
Handle not in position.
Chute is difficult or impossible to turn. Chute lever lower rod is not fully seated. Remove lower part of chute lever from
Snow blower not starting.
The motor is on but the impeller does
not turn.
After passing, the snow blower leaves
a layer of snow on the ground.
This product has a Five-year Limited Warranty for personal, family,
or household use (90 days for business or commercial use).
For warranty details, visit www.ryobitools.com

TROUBLESHOOTING

POSSIBLE CAUSE
Handle adjustment knobs and/or handle
lock clips are not secured.
Battery is low in charge.
Start button is not depressed.
The drive belt is worn or broken.
The impeller/scraper mechanism is
worn.
MAKE THE MOST OF YOUR PURCHASE!
Go to http://register.ryobitools.com and register your new tool on-line.
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
For any questions about operating or maintaining
your product, call the RYOBI Help Line!
or call (toll free) 1-800-860-4050.
11 — English
SOLUTION
Make sure handle adjust knobs are
fully seated and handle lock clips are
fully closed.
blower housing. Manually position
chute so it is facing forward, then
reinstall chute lever.
Charge the battery.
Press start button.
Have the drive belt replaced by an
authorized service center.
Have the impeller/scraper mechanism
replaced by an authorized service
center.