Intended Use; On/Off Switch; Variable Speed Control - Worx Professional WU462 Traducción De Las Instrucciones Originales

Symbols
To reduce the risk of injury, user must read instruction manual.
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist. Check
with your Local Authority or retailer for recycling advice.
All manuals and user guides at all-guides.com
1
2
3
8
Operating instructions
note: Before using the tool, read the instruction book carefully.

InTenDeD USe

The machine is intended for sawing wood, plastic, metal and building
materials while resting firmly on the workpiece. It is suitable for
straight and curved cuts with mitre angles to 45°. The saw blade
recommendations are to be observed.

On/OFF SWITCH

Depress to start and release to stop your tool.
LOCK-On BUTTOn
Depress on/off switch (1) then lock-on button (2) (See A), release
on/off switch first then lock-on button second. Your switch is now
locked on for continuous use. To switch off your tool just depress and
release on/off switch.

VARIABLe SPeeD COnTROL

The variable speed control is at the rear of the machine. Adjust the
variable speed control to increase or decrease the speed (See B)
according to the material, material thickness and blade specification
to be used (also possible during no load operation). See Chart 1 for
general guidance on speed selection.
Avoid prolonged use at very low speed as this may damage your
jigsaw's motor.
Chart 1
Material Speed setting