GB
1.
Assemble Front wheel:
Insert the front shaft through the hole of the front bracket, and install the wheel, and add the
axle sleeve to make the front shaft through. Add the gasket to the left side and right side, then
tighten with the M10 self-locking nut. (The wheel turns flexibly)
2.
Assemble the front fork frame
Please let the screw hole of the front fork (1) frame is aligned with the hole in the front of the
car body, Then tighten with the M8X135 (2) screws through the upper hole, and tighten with
nuts.(3)
3.
Assemble the left pedal
Please stick the pedal into the car body slot and fasten it.
4.
Assemble the training wheel:
Please make the body bottom face up, then square tube upward hole on the left and right
pedal's tipping hole with two pcs 4 X12 Self-tapping screws with gaskets respectively tighten.
5.
Assemble front bracket trims and front wheel mud panels
Clamp the trims and the front wheel mud plates in the direction of the front support.
6.
Battery connection
Connect all connectors as shown in figure 6. Only plug matching connectors into eachother
and be sure not to reverse the polarity. Make sure the red wire is well connected with the
red terminal on the battery, and same as the black one.
3
1
Problem
The battery can no longer be charged
The battery can no longer be charged although the battery and charger
are OK.
The journey time is very short.
No function
Can be switched on but does not drive.
Can be switched on but does notmove, or only direction.
The active fuse blows and switches the unit off for a few seconds. You will
hear a single click at the beginning
Vehicle has very high wear on switches.
Wheel keeps falling off the axle.
Only use in direct supervision of an adult!
To control the vehicle a minimum skill level and caution is needed. Make sure you are familiar with the operation of the model and its characteristics. The model is heavy. This is an
increased risk of injury and damage in the event of loss of control. Avoid any kind of intentional or unintentional collisions with objects or hazards to persons.
Caution
Always switch off the model immediately after each use. Immediately after each use the battery should be disconnected from the model. The battery can be deeply discharged by leaving
it switched on accidentally or leaving it plugged in. Deep discharge causes the battery to lose power or can be damaged to such an extent that charging or discharging is no longer
possible or the battery can self-ignite during charging or discharging (fire hazard). Never attempt to charge or discharge deeply discharged batteries. The battery voltage should never
fall below 5,7 volts to avoid deep discharge. The fully charged battery has a voltage of approx. 6,5 Volt. After use, the intact battery should be fully charged immediately after a cooling
phase of at least 10 minutes but at the latest after 12 hours to avoid subsequent deep discharge by self-discharge. If the battery is not used or stored for a longer period of time, the
battery should be checked for voltage (min. 6,2 volts) or damage at least every 3 months and charged or disposed of if necessary.
6
4
2
5
Source
Carger or battery defective.
Charging socket defective (if present)
The battery has been deep discharged or is worn out.
Battery is not or incorrectly connected.
ON/OFF switch defective.
Motor cable incorrectly connected or not connected.
Gas or direction switch defective.
Oberload or electrical short circuit.
Dirt and moisture damage the switches.
Mounted incorrectly.
7.
Charging your model
• The power swich must be turned in OFF position when charging.
• Insert the charger into the socket - the LED lights up green. Connect the charger to the
charging socket.
• The LED on your charger lights up red as long as the battery is being charged. If the LED
lights green again, the battery is fully charged.
• The charge time is 10 hours.
• Do not charge the battery more than once within 24 hours.
• Charger and battery heat up during the charging process.
Warning!
•
Let the model cool off sufficiently after each use before putting it back into operation.
When using an additional batteries let it cool off for minimum 15 minutes until the
model is operated again. Overheating can damage the electronics or may result in fire.
•
Always disconnect the model from the charger immediately after charging. Always
disconnect the charger from the power supply immediately after disconnecting the
model. Inserting the rechargeable model or charger after charging will result in damage
to the model, charger or the power supply (fire hazard).
Functions
1
ON/Off switch
With the ON / OFF switch you start the vehicle.
2
Shift Lever:
Forward:
Press the "Forward-backward switch" on the "Forward" position.
Press the "Foot pedal", the model drives forward.
Stop:
The model will brake automatically, when your child's foot remove from the
"Foot pedal". Press the "Forward-backward switch" in the middle.
Reverse:
Press the "Forward-backward switch" on the "Backward" position.
Press the "Foot pedal", the model drives backward.
Important!
The vehicle must be stationary before changing direction. Otherwise the gear unit and/or
the motor could be damaged.
3
Music
Press to play music
4
Horn
5
Foot pedal
To move the car, press the pedal down.
To brake or slow down, release pressure from the pedal.
Solution
Check charger and battery
Check or replace the charging socket.
Use a new battery and avoid deep discharge.
Connect the battery (see instructions)
Check or replace switch.
Check and connect motor cable (see instructions).
Check or replace switch.
Do not overload or have the until checked.
Do not drive in moisture or dirt such as meadows, gavel, sand, etc.
Check that the wheel is properly engaged (see instructions).
