Tech-Air ® Support; Certification Information - Alpinestars Tech-Air 5 System Guia Del Usuario

19. Tech-Air
®
In case of questions or should the users need further information, they may first contact
Tech-Air Dealer where the System was purchased, or Alpinestars directly:
®
E-mail: [email protected]
Tel: +39 0423 5286 (asking for Tech-Air

20. Certification Information

The Tech-Air 5 System is covered by a number of certifications.
®
Personal Protective Equipment
The Tech-Air 5 System is considered Category 2 Personal Protective Equipment under
®
EU Regulation 2016/425. As such a EU Type examination has been conducted. As the
motorcyclists' inflatable protectors standard (EN1621-4:2013) is for mechanically triggered
systems, this has been used with reference to impact performance and ergonomics only.
The examination was conducted by:
- Notified Body #0598 SGS Fimko Oy, Takomotie 8, 00380, Helsinki, Finland
The explanation of the product markings are as follows:
Indicates that
an inflatable
protector is
installed
Garment Size
(Waist to
Shoulder) Sizing.
See Table in
Section 6
Protection Level
The following table summarize and explain the performance level reported on the product
marking as an inflatable impact protector:
Standard
Tested Area Used for
tests
Central Back 1621-4:2013
Passive Back Protector
Tech-Air 5 System, is equipped with a passive back protector that provides protection
®
to the back area even if the System should not deploy. This back protector is certified as
a Personal Protective Equipment Category 2, Level 1, under the Regulation EU 2016/425,
according to the 1621-2:2014 standard. The examination was conducted by:
- Notified Body #0120 SGS United Kingdom Limited, Park Way, Weston Super Mare, BS22
6WA, UK
Support
Support)
®
EU 2016/425 CAT II
AIRBAG
2 CB
44 - 48 cm
Temperature
20°
ABS520
0080
AIRBAG MODULE
0080.P1.15.0023
Level
Level 1 requirements:
average value ≤ 4.5kN; No
Force
impact above 6kN
Transmitted
Level 2 requirements:
average value ≤ 2.5kN; No
impacts above 3kN
Average 0.9kN
Level 2
Peak 1.24kN
Product
Identification
Code
Indicates that
the product is
for motorcycle
use, meets
Central Back,
Level 2 airbag
requirements
Name of the
Manufacturer
25 EN