Intended Use - Worx MAKER X WX741 Manual Original

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.

INTENDED USE:

The machine is intended for cutting, roughing and brushing metal and stone
materials without using water. For cutting metal, a special protection guard for
cutting (accessory) must be used.
ASSEMBLY
1. Mount the guard as needed. (See Fig.A1)
Press and hold the spindle lock button, assemble the wheel and flange, then use the
hex key to tighten. (See Fig. A2)
NOTE: Always ensure the workpiece is firmly held or clamped to prevent movement.
The angle grinder can work with Butterfly-style arbors such as the EZ-Lock ® discs
of Dremel®. Dremel and EZ-Lock are trademarks of Robert Bosch Tool Corporation.
(See Fig. A3)
2.Connect the angle grinder to the hub. (See Fig. B)
WARNING: Before operation, make sure the speed control button on the
hub is at the"Min" position. (See Fig. C)
OPERATION
EN
1. Confirm the speed control button is set to "Min". Grasp the tool by the grip. Press
17
the on/off switch on the hub and that on the angle grinder to start the machine. (See
Fig. D)
CAUTION: Do not use damaged or worn accessories. Make sure the machine is in
perfect condition.
NOTE: Always start at no load to achieve maximum speed then start working. Do not use
excessive contact pressure! A correct and uniform speed enables better performance.
2.Adjust speed as needed. (See Fig. E)
NOTE: After usage, press the on/off switch on the hub and that on the angle grinder
to turn off the machine and disconnect it from the hub. For sake of safety, adjust the
speed control button to "Min" position once completing the operation.
3.Replace the disc. (See Fig. F)
Press and hold the spindle lock button and use the hex key to loosen.
NOTE: Before changing the accessory, make sure your machine is turned off and
disconnected from the hub or battery.
NOTE: 2 spare screws for the guard, and 1 spare blade flange have been included
with your tool, in case the original pieces become lost.
WARNING: Never use a cutting disc for roughing.