Intended Use - Worx WT649.1 Manual Original

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.

INTENDED USE

The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.The sander is not to be
used for plastering.
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
* Fitting the Sanding Paper
12 Attaching the Dust Box
CAUTION: To prevent the
possibility of sanding dust or
foreign body being thrown into your
face or eyes, never attempt to use
your sander without the dust box
properly installed.
Emptying the Dust Box
-For more efficient operation, empty
dusts box every 5-10mins.
OPERATION
On/Off Switch
Flush Sanding Facility
* Installing The Finger Pad
* Removing The Finger Pad
* Attach Sanding Sheets And Pads
Sanding With Finger Pad
*
serious personal injury.
FIGURE
WORK HINTS FOR YOUR PALM SANDER
If your power tool becomes too hot, run no load for 2-3
See Fig. A
minutes to cool the motor.
Always ensure the work-piece is firmly held or clamped to
prevent movement.
Any movement of the material may affect the quality of
the sanding finish.
See Fig. B
Start your sander before sanding and turn off only after
stopping sanding. For best results sand wood in the
direction of the grit.
Do not start sanding without sandpaper fitted.
Do not allow the sandpaper to wear away, it will damage
See Fig. C1,
the base-plate. The guarantee does not cover base-plate
C2, C3
wear and tear.
Use coarse grit paper to sand rough surfaces, medium grit
for smooth surfaces and fine grit for the final surfaces. If
necessary, first make a test on scrap material.
Use only good quality sandpaper.
See Fig. D
The sanding efficiency is controlled by the sandpaper not
the amount of force you apply to the tool. Excessiveforce
See Fig. E
will reduce the sanding efficiency and cause motor
overload. Replacing the sanding paper regularly will
WARNING: Failure to unplug the sander could
result in accidental starting causing possible
See Fig. F1, F2
See Fig. G1, G2
See Fig. H
See Fig. I