Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Explosion Hazard
Keep flammable
materials
and vapors, such as
gasoline,
away from refrigerator.
Failure to do so can result in death, explosion, or fire.
IMPORTANT= This refrigerator
is designed for indoor, household
use only.
To ensure proper ventilation
for your refrigerator,
allow 1/2"
(1.25 cm) of space on each side, and between the top of the
refrigerator
and overhead cabinets. Allow 2" (5 cm) of space
behind the refrigerator.
If your refrigerator
has an ice maker,
allow extra space at the back for the water line connections.
When installing your refrigerator
next to a fixed wall, leave a
31/8" (8 cm) minimum space on the hinge side to allow the door
to swing open.
NOTE= This refrigerator
is intended for use in a location where
the temperature
ranges from a minimum of 55°F (13°C) to a
maximum of 110°F (43°C). The preferred
room temperature
range for optimum performance,
which reduces electricity
usage and provides superior cooling, is between 60°F (15°C)
and 90°F (32°C). It is recommended
that you do not install the
refrigerator
near a heat source, such as an oven or radiator.
3%" (8 cm)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Before you move your refrigerator
into its final location, it is
important
to make sure you have the proper electrical
connection.
Recommended
Grounding Method
A 115 volt, 60 Hz, AC only, 15- or 20-amp fused, grounded
electrical
supply is required. It is recommended
that a separate
circuit serving only your refrigerator
be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE= Before performing
any type of installation
or cleaning, or
removing a light bulb, turn cooling off or turn the control
(Thermostat, Refrigerator
or Freezer Control depending
on the
model) to OFF, and then disconnect the refrigerator
from the
electrical
source. When you are finished, reconnect the
refrigerator
to the electrical
source and turn cooling on or reset
the control (Thermostat, Refrigerator
or Freezer Control
depending
on the model) to the desired setting. See "Using the
Controls" in the User Instructions, User Guide, or Use & Care
Guide.
Gather the required
tools and parts before
starting
installation.
Read and follow the instructions provided
with any tools listed
here.
IMPORTANT:
•
If you turn the refrigerator
on before the water line is
connected, turn the ice maker OFF.
•
All installations
must meet local plumbing code
requirements.
•
Use copper tubing and check for leaks. Install copper tubing
only in areas where the household temperatures
will remain
above freezing.
TOOLS NEEDED= Flat-blade
screwdriver, 7_,, and _/_"open-end
wrenches or two adjustable wrenches, %" nut driver and drill bit,
cordless drill.
Tabla de contenido
