Refrigerator Use - Sears Kenmore 106.8639 Serie Manual De Uso Y Cuidado

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Your refrigerator
has two adjustable
levelers, one on each side,
at the base of the refrigerator.
If your refrigerator
seems
unsteady or if you want the doors to close more easily, adjust
the level and tilt of the refrigerator.
1. Turn the leveler to the left to raise that side of the
refrigerator
or to the right to lower that side. It may take
several turns to level the refrigerator.
NOTE= Having someone push against the top of the
refrigerator
takes some weight off the levelers. This makes it
easier to turn the levelers.
2. Once the refrigerator
is level from side to side, raise the
front levelers so that the refrigerator
is tilted slightly
(approximately
1/2") downward
to the rear. The doors will
close more easily and the freezer door will remain closed
whenever you close the refrigerator
door.
3. Open both doors again to make sure that they close as
easily as you like. If not, tilt the refrigerator
slightly more to
the rear by turning both levelers to the right. It may take
several more turns.
4.
NOTE= To keep the refrigerator
level, make the same
adjustment to each side.
Using a level, make sure the refrigerator
is still level from
side to side. Readjust if necessary.
Your refrigerator
is designed to run more efficiently
to keep
your food items at the desired temperatures
and to minimize
energy usage. The high efficiency
compressor and fans may
cause your refrigerator
to run longer than your old one. You
may also hear a pulsating or high-pitched
sound from the
compressor or fans adjusting to optimize performance.
You may hear the evaporator
fan motor circulating
air
through the refrigerator
and freezer compartments.
The fan
speed may increase as you open the doors or add warm
food.
Rattling noises may come from the flow of refrigerant,
the
water line, or items stored on top of the refrigerator.
Water
dripping on the defrost heater during a defrost cycle
may cause a sizzling sound.
As each cycle ends, you may hear a gurgling
sound due to
the refrigerant
flowing in your refrigerator.
Contraction
and expansion of the inside walls may cause a
popping
noise.
You may hear air being forced over the condenser by the
condenser fan.
You may hear water running into the drain pan during the
defrost cycle.
REFRIGERATOR USE
In order to ensure proper temperatures,
you need to permit
airflow
between the refrigerator
and freezer sections. As shown
in the illustration,
cool air enters through the bottom of the
freezer section and moves up. Most of the air then flows through
the freezer section vents and recirculates under the freezer floor.
The rest of the air enters the refrigerator
section through the top
vent.
NOTE= Depending on your model, the refrigerator
may have
either a Normal flow or Multiflow
air system.
Your new refrigerator
may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal.
Hard surfaces, such as the floor, walls, and cabinets, can make
the sounds seem louder. The following
describes the kinds of
sounds and what may be making them.
If your refrigerator
is equipped with an ice maker, you will
hear a buzzing sound when the water valve opens to fill the
ice maker for each cycle.
Do not block any of these vents with food packages. If the vents
are blocked, airflow will be restricted and temperature
and
moisture problems may occur.
IMPORTANT= Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.
12
Tabla de contenido
loading

Tabla de contenido