Ryobi BID1821 Manual De Utilización página 6

GB
FR DE ES
OPERATION
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
normal part of the switch function.
DIRECTION OF ROTATION SELECTOR
(FORWARD/REVERSE/CENTER LOCK)
See Figure 3.
The direction of bit rotation is reversible and is controlled
by a selector located above the switch trigger. With the
drill held in normal operating position, the direction of
rotation selector should be positioned to the left of the
switch trigger for forward drilling. The drilling direction is
reversed when the selector is to the right of the switch
trigger.
Setting the switch trigger in the OFF (center lock) position
helps reduce the possibility of accidental starting when
not in use.
CAUTION:
To prevent gear damage, always allow the chuck
to come to a complete stop before changing the
direction of rotation.
To stop, release switch trigger and allow the coupler to
come to a complete stop..
BUILT-IN COUPLER
See Figure 4.
The tool has a built-in coupler. The coupler has been
designed to accept 6.35 mm hex bits.
INSTALLING BITS
See Figure 4.
„
Lock switch trigger on the tool by placing the direction
of rotation selector in center position.
„
Slide the coupler forward and hold in position.
„
Insert bit straight into coupler.
„
Slide the coupler back slowly and release.
REMOVING BITS
See Figure 4.
„
Lock switch trigger or the drill by placing the direction
of rotation selector in center position.
„
Slide the coupler forward and hold in position.
„
Pull bit straight out of coupler.
IT NL PT DK SE FI NO RU PL CZ
English
WARNING
Make sure the bit is secured in the coupler
before using the impact driver. Failure to do so
could cause serious personal injury.
WARNING
Do not drive a screw where there is likely to
be hidden wiring behind the surface. Contact
with a "live" wire will make exposed metal parts
of the tool "live" and shock the operator. If you
must drive a screw where hidden wire may be
present, always hold tool by insulated gripping
surfaces (handle) when performing the operation
to prevent a shock to the operator, as seen in
figure 5.
CAUTION:
The impact driver is not designed to be used as
a drill.
DRIVING OR REMOVING SCREWS
See Figures 5 - 6.
„
Place the direction of rotation selector in the correct
position for the operation.
„
Hold the impact driver with one hand.
„
Place the bit on the screw head and slowly depress
the switch trigger. Start the bit slowly for more control.
„
As the screw is driven, impacting will begin.
MAINTENANCE
WARNING:
When ser vicing, use only identical Ryobi
replacement parts. Use of any other parts may
create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses
with side shields during power product operation
or when blowing dust. If operation is dusty, also
wear a dust mask.
WARNING:
To avoid serious personal injury, always remove
the battery pack from the product when cleaning
or performing any maintenance.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
3
HU RO LV LT EE HR SI SK GR TR