Brinly SAT-40 BH Manual Del Usuario página 6

================================================================================================
ASSEMBLE TINES TO AXLE
Step 3.
3a. Place a 5/8" Flat Washer, Thick (17) onto
the Axle Assembly (6), then slide it through
the hole in End Panel (5 right Side) and add
another Flat Washer Thick (17) if needed.
3b. Position the eleven Tines (7) and twenty-two
Spacer/Bearing Tubes (27) onto the Axle
Assembly (6) as follows:
• Bearing, small end first
• Aerator Tine
• Bearing, large end first
Note: Round projections on Spacer /
Bearing flanges must fit into small holes in
aerator tines and into two holes of opposite
Spacer/Bearing
3c. Position one or two Washers (17 or 28) as
needed to eliminate any side-to-side movement
and push Axle Assembly (6) through hole in
the left End Panel (5) as far as possible. See
layout below.
WARNING: Gloves are required when handling
aerator tines. Tines have extremely sharp points.
Use caution when handling.
Note: Tines must not move from side to side inside opening of end panels. If looseness exists, use additional 5/8"
Thick or Thin Washers (17 or 28) inside End Panel to eliminate any side movement.
All manuals and user guides at all-guides.com
ASSEMBLY
5
Tine and Spacer/Bearing Tube Layout:
• Spacer/Bearing Tube (small end first)
• Aerator Tine
• Spacer/Bearing Tube (large flange first)
Page 6
6
17
28
27
5/8" Washer
(thin)
Qty. 2
17
28
7
17
5/8" Washer (thick)
Qty. 4
L-1643BH-H