Makita 6226D Manual De Instrucciones página 6

For DC9711
1. Plug the battery charger into your power source.
2. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as
their respective markings on the battery charger. Insert the cartridge fully into the port so that it rests on the
charger port floor.
3. When the battery cartridge is inserted, the charging light will come on and charging will begin.
The charging light will keep lighting up steadily during charging.
4. When charging is completed, the charging light goes out. The charging time is as follows:
Battery 7000, 7100, 7120, 9000, 9100, 9100A and 9120: approx. 60 minutes.
Battery 7001, 9001, 9101 and 9101A: approx. 80 minutes.
Battery 7002, 9002, 9102, 9102A and 9122: approx. 90 minutes.
Battery 7033, 9033 and 9133: approx. 100 minutes.
Battery 9134: approx. 115 minutes.
Battery 9135: approx. 130 minutes.
5. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its
"trickle charge (maintenance charge)" mode which will last approximately 24 hours.
6. After charging, unplug the charger from the power source.
CAUTION:
• The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufac-
turer's batteries.
• If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location
exposed to direct sunlight for a long time, the charging light may flash in red color. If this occurs, wait for a while.
Charging will begin after the battery cartridge cools.
For DC1411
Your new battery cartridge is not charged. You will need to charge it before use. Use the battery charger Model
DC1411 to charge the battery cartridge.
Plug the battery charger into the proper A/C voltage source. The charging light will flash in green color. Insert the bat-
tery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective
markings on the battery charger. Insert the cartridge fully into the port so that it rests on the charger port floor. When
the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The
charging light will remain lit steadily during charging. When the charging light color changes from red to green, the
charging cycle is complete. The charging time is approximately one hour. If you leave the battery cartridge in the
charger after the charging cycle is complete, the charger will switch into its "trickle charge (maintenance charge)"
mode which will last approximately 24 hours. After charging, unplug the charger from the power source. Refer to the
table below for the charging time.
Battery type
9120
9133
9134
9135
1220
1233
1234
1235
1420
1433
1434
1435
6
All manuals and user guides at all-guides.com
Capacity (mAh)
1,300
2,200
2,600
3,000
1,300
2,200
2,600
3,000
1,300
2,200
2,600
3,000
Number of cells
8
8
8
8
10
10
10
10
12
12
12
12
Charging time
Approx. 40 min.
Approx. 65 min.
Approx. 75 min.
Approx. 90 min.
Approx. 40 min.
Approx. 65 min.
Approx. 75 min.
Approx. 90 min.
Approx. 40 min.
Approx. 65 min.
Approx. 75 min.
Approx. 90 min.