TECO 680 Manual De Instrucciones página 87

- if only one measurement is taken, the machine interprets the presence of a rim with balanc-
ing using a clip weight on both sides (Dynamic balancing Programme);
- moving the arm to the rest position, the machine will set up for the manual WIDTH entry;
- in this phase, it is possible to perform an additional acquisition of the rim diameter and
distance.
- Measure the width of the rim using the provided calliper (Fig. 16).
- Change the displayed width value by increasing or decreasing the value using the keypad.
After updating the wheel data the user can:
1) press the Exit
new dimensions;
2) press the ENTER button to access the manual dimension program to convert and/or change
the wheel data.
- if two subsequent measurements are taken inside the rim on two balancing planes, the ma-
chine interprets the presence of a rim with balancing using a clip weight on the inner plane
and an adhesive weight on the external one (ALU 2P). In this phase, the machine could
automatically change the type of weight on the inner plane from clip to adhesive (ALU 1P).
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
button to display the unbalance values recalculated according to the
16
EN
87