Using The Automatic Wheel Clamping System - TECO 680 Manual De Instrucciones

The functions of every icon in the main menu are listed below:
1. Balancing programme icon
; if called up, it groups the functions relating to the balancing types.
2. the utility and configuration programmes
tion programmes of the machine.
3. the highest accuracy
possible accuracy ("Gr x1" or "Oz 1/10");
4. the help
displayed, the first piece of information displayed concerns the type of errors that may oc-
cur. The instructions called up by this icon integrate (but do not replace) this User Manual.
by default the icons relating to points 3 and 4 are those described above but can be replaced
with more frequently used ones (refer to the "Preferred programme configuration" section).
USing THE aUTomaTiC WHEEl
Procedure for locking the wheels with the automatic PL system:
Centring with front cone
- Fit the wheel on the shaft, sliding it into place until it rests against the flange.
- Fit the most suitable cone on the shaft and insert it into the central hole of the wheel.
- Fit the locking device by making it slide on the hub until it comes into contact with the cone.
- Press the control pedal for at least one second.
Centring with rear cone
- Fit the most suitable cone for the central hole of the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into place until the cone comes into contact with
the plate that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on the hub until it comes into contact with the
wheel.
- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second to release the wheel from the flange.
84
icon allows balancing results to be displayed with best
icon displays information on the current screen. If an error message is
ClamPing SYSTEm Pl
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
icon groups all utility and configura-