TECO 680 Manual De Instrucciones página 101

- at the end of the spin, select the balancing programme icon
ENTER button until the required programme is selected;
- for the application of the adhesive weight, always use 12 o'clock as a reference regard-
less of the setting in Configuration of Adhesive Weight Application Position.
best results can be achieved if the adhesive weights are positioned with the outer edge
being flush with the rim edge.
Some rims have spokes so wide that it is not possible to place adhesive weights next to
them; a programme which divides the counterweights into two parts has been introduced
to solve this problem.
In this case, when the centred position is reached and it becomes obvious that the balanc-
ing weight will have to be applied in line with a spoke, proceed as follows:
- remain in the centred position;
- select the
grammes" icon);
- select the spoke dimension on the displayed window using the keypad: small, medium,
large or OFF (selection deactivated);
- confirm by pressing the Enter button
- apply two new counterweights in the positions indicated.
The weight division operations can be performed on both balancing sides.
A wheel can be balanced using a single counterweight on one of its two sides or in
the centre of the well. in this case, the wheel is balanced statically. However, there is
still the risk of dynamic unbalance, which becomes more significant as the width of the
wheel increases.
Proceed as follows to balance motorcycle or car wheels statically:
- Perform a spin.
- at the end of the spin, select the Balancing programme icon
until the required programme is selected;
- select the Static balancing programme icon
The displayed image now shows only one position search.
- Apply the balancing weight in the 12 o'clock position on either the outer or inner side,
Operator's manual TECo 680 - 680 PlUS - 680 PlUS Pl
Split Weight Programme
Divide side weight icon (displayed instead of the "select ALU pro-
Static balancing
;
.
and press the
and press ENTER
101
EN