Sangean ATS-909X Manual De Instrucciones página 29

Note:
When the buzzer alarm activates, the alarm will start softly and
GB
gradually increase in level. It will sound for  minute and silence for
 minute in repetition for 30 minutes unless cancelled. The radio
will sound non-stop at the selected time for up to 60 minutes for
other radio alarm types.
To set radio for an alarm timer, first press one of the TIMER buttons
and (SSB)/RDS/Alarm MODE button until Radio Alarm icon flashes
on the display. Then set up the alarm time (hours and minutes)
by using the numerical keys on the key pad and Enter Selection
button. When the sounds beep it means the alarm has been
activated.
Then tune to the station you would like to be awaken to. Press the
Memo button and then press the TIMER button number. When the
sounds beep it means the alarm has been activated. Your radio will
automatically switch on at the setup time.
In addition to being able to set 3 different wake up times it is
possible to set each wake up time to a different frequency. To view
the setting of an active timer, press the required TIMER button. The
timer number and the alarm time or the radio alarm frequency can
be viewed flashing in the LCD display.
The active alarm may be stopped by pressing the STANDBY/
SLEEP button. To permanently disable the alarm, press the
required TIMER button number followed by the Cancel button.
Then the timer number will disappear on the display.
28