Sangean ATS-909X Manual De Instrucciones página 21

MANUAL TUNING (ROTARY TUNING)
Manual Tuning is accomplished using the convenient Rotary Tuning
Knob.
The Step button is used to determine the tuning spread for
each step of the Rotary Tuning Knob. Spread may be changing
accordingly:
Press and release the Step button to select the step in FAST or
SLOW mode. Press and hold Step button to stop or enable the
step in FAST or SLOW mode.
STEP
STOP
FAST 00kHz
SLOW 50kHz
AUTO/MANUAL SCAN TUNING
To start Auto Scan Tuning, select band to tune press one of the
Tuning Up/Down buttons for more than 0.5 second. Once scan
starts, release button. The Auto Scan stops as soon as a station of
adequate signal strength is located. Repeat operation to start scan
tuning again. Scan tuning can be halted by pressing the Tuning Up/
Down buttons momentarily any time during the scanning process.
To manually tune to a frequency of your choice repeatedly, press
and release one of the Tuning Up/Down buttons until the frequency
desired is displayed.
TUNING STEP ON EACH BAND
FM LW
0 0
9kHz
kHz
MW SW
0 0
9/0kHz 5kHz
kHz kHz
GB
LSB/USB
0
kHz
40kHz
20