Base Speed Dial Setting; Base Ringer Setting; Multi-Base Setting; Call Manager - EnGenius EP801 Manual De Usuario

Call a Caller ID
1. Press
key, use or
2. When display a caller ID, Press

Base Speed Dial Setting

1. You can store up to 20 entries in the speed dial memory. Each speed
dial memory can contain a phone number (up to 32 digits).
2. Base during standby mode, press
number.
3. Press
key, followed by a 2-digit memory location, base then will
emit a two short tone (Bi-Bi) to confirm the setting.
Re: The memory location is "00" ~ "19".
4. When using the base speed dail, press
key, then enter the 2-digit memory location ("00"~"19").
The base will dial the telephone number accordingly.

Base Ringer Setting

1. You can change the base ringer by following :
2. Base during standby mode, press
or key, the base speaker will emit the varied ringer (up to 8
ringer tones).
3. Press
key to confirm the setting.
4. To adjust the ringer volume, two options can be followed:
a. Base during standby mode, press
b. When incoming call, press
c. When press or key to adjust the volume, the speaker will
emit the loudness of ringer, you can choose the preference.
Re: The loudness level of ringer is "0~4", "0" means ringer "Off".
key to scrool the call log.
or to dial this number.
key, enter the telephone
key followed by
key twice, followed by
or key.
or key.
~45~

Multi-Base Setting

"Multi-Base" setting allows expanding coverage or lining capacity. When
nd rd th
adding 2 , 3 or 4 base, using one of the handsets which registered to the
st
1 base (i.e. the handset with ID 11), followed by below processes：
1. Press MENU, followed by "7" to enter the registration
mode.
2. Press & hold the base REG button for thress seconds,
the base will emit the prompt ringing (also the base
speakerphone & Intercom LED is flashing).
3. Press digit "3" of handset to enter the Multi-Base
mode.
4. Select BS # 1
5. Repeat above step 1 ~ 4 to continuously add the 2
rd th
3 or 4 base.
st
Re：The base ID for 1 base is "10", for 2
rd
"20", for 3 base is "30", for 4
Notes:
1. When initial setting the "Multi-Base", you have to select the BS #1
first, then followed the above steps to select 2
2. For synchronization mechanism, all handsets must be register again
before start using multi-base scenario. i.e. the initial handset ID with
1x must register to BS1, and the rest handsets must be registered to
nd rd th
2 , 3 or 4 base respectively.
3. After all above processes, the "Multi-Base" is complete then.

Call Manager

"Call Manager" feature allows two options：
nd
,
nd
base is
th
base is "40".
nd rd th
, 3 or 4 base.
~46~