Troubleshooting; Error Display - Wellion WAVE professional Manual De Instrucciones

TROUBLESHOOTING

If you have trouble in using the product please check the following points first:

Error display

Nothing is displayed when
you push the POWER button
or battery icon flashes
E0: device can't detect the
signal of pulse
E1: can't normally Increase
pressure
E3: inflate pressure too high
E2E4: shaking while mea-
surement
Battery icon displayed
The systolic or diastolic
pressure value is too high
The systolic or diastolic
pressure value is too low
Possible cause
No battery installation
Battery worn out
The polarities of batteries placed wrongly
There may be many clothes between the cuff and
upper arm. Please wear a thin shirt when measuring.
The cuff may be worn in wrong direction, and the
tube interface does not correspond to the arterial
position.
If the E0 error code is not caused by the above men-
tioned reasons, the device is defect.
Check that your arm cuff has no air leakage
Hand or body shaking while measurement
Batteries have low power
The arm cuff was held lower than your heart
The arm cuff was not attached properly
You moved your body or spoke during measurement
The arm cuff was held higher than your heart
You moved your body or spoke during measurement
How to correct
Insert batteries
Replace batteries
Insert battery in the correct
polarities
Constriction of the upper arm,
caused by rolling up a shirtsleeve,
may prevent accurate readings.
Replace arm cuff with new one
Re-measurement or have the
device re-calibrated
Keep static and correct gesture to
measure again
Replace batteries and repeat the
measurement
Keep correct position and gesture
to measure again
Keep correct position and gesture
to measure again
EN
27