Operating Procedure; Proper Hand Position; Tool Operation - Stanley PB2500 Smart Manual De Instrucciones

E N G L I S H
•
Slide it into the handle until the battery pack is firmly seated in the tool and ensure that it does not
disengage.
TO REMOVE THE BATTERY PACK FROM TO THE HANDLE
•
Press battery release button and firmly pull the battery pack out of the tool handle.
•
Insert battery pack into the charger as described in the charger section for this manual.
Storage Recommendations
•
The best storage place is one that is cool and dry away from direct sunlight and excess heat or cold. For
optimum battery performance and life, store battery packs at room temperature when not in use.
•
For long storage, it is recommended to store a fully charged battery pack in a cool, dry place out of the
charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery pack will need to be re-
charged before use.

5. OPERATING PROCEDURE

WARNING: Always observe the safety instructions and applicable regulations.
WARNING: To reduce the risk of serious personal injury, disconnect battery pack before making any
adjustments or removing/installing attachments or accessories.
WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position.
WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a
sudden reaction
5.1

PROPER HAND POSITION

Proper hand position requires one hand on the main handle (I) fig. 1.
5.2

TOOL OPERATION

Installing a blind rivet (fig. 8)
Read a Smart Touch Screen Operating Manual to know the details of how to use the touch screen.
Please visit our website http://www.stanleyengineeredfastening.com/resource-center/document-library
To install a blind rivet
•
Place the blind rivet (Y) in the nosepiece (A)
•
Position the tool (fig.9)
•
Pull and hold the switch (J) until the rivet is fully set in the application (fig. 10).
•
When the blind rivet (Y) has been set completely, release the switch (J). The tool will return to its initial
position automatically. The mandrel is automatically dropped into the mandrel collector (W).
If you release the switch (J) before the end of the setting stroke, the tool will immediately return to its initial
position. If the blind rivet (Y) has not been set completely, repeat the previous steps.
In case Auto return mode was enabled, once the tool detects a rivet setting, it will return to its initial position
automatically even if the trigger remains holding.
Reset function (fig.9)
If the tool does not move to its initial position after releasing the switch or stops during the setting stroke, reset
the tool to home by quickly pulling and releasing the switch (J). If this does not resolve the issue, remove the
battery, re-insert and then repeat the prior step. If the issue persists, contact your local service representative.
16