Kenwood FDM30 Manual De Instrucciones página 15

Express Dice
22
a
Dicing disc
b
Dicing grid
c
Dicing pusher
Important: the dicing disc is designed only to be
used with the dicing attachment.
To use the Express Dice
1 Fit the drive shaft and bowl onto the power
unit.
2 Add the dicing disc and fit the lid.
3 Fit the dicing grid into the feed tube.
4 Switch on and use the dicing pusher to
process food items through the dicing grid.
Hints and Tips
To assist with processing place both hands on
top of the pusher and press down firmly.
For best results, use raw fresh fruit and
vegetables.
To prevent the food from jamming do not
pack the food tightly in the feed tube –
ideally the food should be cut no larger than:
50 × 30mm
If the food is too hard to push through the
grid cook for approximately 10-15 minutes,
then allow to cool in a refrigerator before
processing.
Always remove hard skins, stones, pips and
seeds etc., from food before processing.
Note:
Due to the various sizes and shapes of
foods, the diced results will contain some
misshapen pieces, this is normal.
Foods such as cheese, ham, and chorizo will
clog in the grid so are not recommended for
use with this attachment.
Cleaning the grid
Use the end of the pusher to dislodge any food
which may become trapped in the dicing grid.
22A
The Express Dice can also be used to
produce French fries, crudités and batons.
1 Fit the dicing grid without the dicing disc.
2 Then manually push the food through the
grid without switching the appliance on.
(if supplied)
Express Serve
23
a
Express serve drive shaft
b
Extension chute
c
Base
d
Slinger plate
1 Fit the drive shaft and bowl onto the power
unit.
2 Fit the small drive shaft to the main shaft – the
Express serve will not operate unless fitted.
3 Fit the required attachment/disc - do not
apply excessive force. Refer to the Discs and
Express Dice sections for further information,
hints and tips.
Use in conjunction with the following:
14-15-16
Important - Dicer and Discs
If the food is not exiting the food outlet, switch
off and check that food is not clogging under
the disc and the slinger plate is fitted. Clear
any trapped food before continuing to process.
Care and Cleaning
Always switch off and unplug before cleaning.
Handle the blade and cutting discs with care
- they are extremely sharp.
Some foods may discolour the plastic. This is
perfectly normal and will not harm the plastic
or affect the flavour of your food. Rub with a
cloth dipped in vegetable oil to remove the
discolouration.
Power Unit
Wipe with a damp cloth, then dry. Ensure that
the interlock area
Do not immerse the power unit in water.
Store excess cord in the storage area at the
back of the power unit
Cleaning Instructions - Refer
to the relevant illustration
9
(if supplied)
22
is clear of food debris.
.
.
24