Kohler 1056336 Manual De Instrucciones

SERVICE KIT INSTRUCTIONS
Supply
Hoses
Faucet/Hose
Connection
Hose
Remove the Existing Hose
Turn off the hot and cold water supplies to the faucet.
Remove the sprayhead from the hose.
Remove the weight assembly from the hose and set aside.
Disconnect the hose from the faucet.
Firmly pull the hose from the spout.
Install the New Hose
Assemble the washer, O-ring, seal retainer and screen gasket to the larger
end of the new hose.
Thread the sprayhead onto the hose.
Feed the remaining end of the hose into the spout.
Measure approximately 9" (22.9 cm) from the faucet/hose connection end
of the hose and attach the lead weight.
Verify the O-ring is in place on the hose.
Make sure both hose ends of the faucet/hose connection are clean.
Connect the hose to the faucet by pushing the faucet/hose quick-
connectors together until you hear them click.
Verify the faucet/hose connection is secure.
Turn on the water supplies and check all connections for leaks.
Turn on the faucet and check all connections for leaks.
Make any adjustments as needed.
Turn off the faucet.
Extend and retract the hose to check for smooth operation. If needed,
reposition the hoses to allow for smoother operation.
Kohler Co.
Spout
Washer
O-Ring
Seal Retainer
Weight
1
PULL-OUT HOSE
1056336
Hose
O-Ring
Screen Gasket
Sprayhead
1017404-9-A
.