Grinding Wheels - DeWalt D28114 Manual De Instrucciones

4-1/2" and 5" Grinding Wheels
Type 27 guard
Quick-change
backing flange
Type 27 depressed
center wheel
threaded clamp nut
Mounting Guard
MOUNTING AND REMOVING GUARD
WARNING: Turn off and unplug the tool before making any
adjustments or removing or installing attachments or
accessories. Before reconnecting the tool, depress and release
the paddle switch to ensure that the tool is off.
CAUTION: Guards must be used with all grinding wheels,
sanding flap discs, wire brushes, and wire wheels. The tool may be
used without a guard only when sanding with conventional sanding
discs. Some D WALT models are provided with a guard intended
E
for use with depressed center wheels (Type 27) and hubbed
Type 27 guard
Type 27 hubbed wheel

6" Grinding Wheels

Type 27 guard
stamped steel
Quick-Change
backing flange
Type 27 depressed
center wheel
threaded clamp nut
grinding wheels (Type 27). The same guard is designed for use with
sanding flap discs (Type 27 and 29) and wire brushes. Grinding and
cutting with wheels other than Type 27 and 29 require different
accessory guards not included with tool. Mounting instructions for
these accessory guards are included in the accessory package.
1. Open the guard latch (M). Align the
lugs (N) on the guard with the slots
(O) on the gear case.
2. Push the guard down until the
guard lugs engage and rotate
freely in the groove on the gear
case hub.
7
Type 27 guard
Type 27 hubbed wheel
N
O
M